Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
according to the steps 1-6 or activate the already entered program by
leaving this menu with the
8. In order to continuously run the entered program the cursor must be
positioned under the PROG symbol. The heater will operate according
to the entered information. When a program is running, the program
number will appear with the pre-set and ambient temperatures
alternating.
9. An entered program can be checked, edited or deleted just by navigating
into the PROG menu and pressing the enter button. With the
buttons the different program numbers can be selected. When a program
number is selected (flashing) the start/stop time will alternate according
to any pre-entered information. To delete one program number, press
button. The CP symbol (clear program) appears and by pressing
the
the enter button
this program will be deleted.
menu without deleting the program.
Time setting (TIME) - see Fig. 9.
Navigate the cursor to TIME with the
to adjust the weekday with the
button
and set the hours and minutes with
or
to leave the time menu.
Frost protection - see Fig. 4.
Choose a heat setting and set the desired ambient temperature between
5°C and 8°C (see 'Operation').
When the temperature falls below +5 °C...+8 °C, the heater switches on
automatically.
Recycling
For electrical products sold within the European
Community.
At the end of the electrical products useful life it should not
be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer
for recycling advice in your country.
button.
leaves the
buttons. Press the enter button
buttons. Confirm with the enter
. Press the enter button
- 2 -
Cleaning
WARNING : ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE
CLEANING THE HEATER
Do not use detergents, abrasive cleaning powders or polish of any kind on
the Controller.
Wipe with a dry cloth to remove dust and a damp cloth (not wet) to clean off
stains. Be careful not to allow moisture into the Controller.
Use a vacuum cleaner to remove any fluff which accumulates on top of the
Controller.
Care must be taken to avoid any moisture ingress into the product.
After Sales Service
Should you require after sales service or should you need to purchase any
spares, please contact the retailer from whom the heater was purchased or
contact the service number relevant to your country on the warranty card.
Please do not return a faulty product to us in the first instance as this may
result in loss or damage and delay in providing you with a satisfactory
service.
Please retain your receipt as proof of purchase.
UK
Advertenties
Inhoudsopgave
