Advertenties
Beschikbare talen
Beschikbare talen
Hidden Helpers
Installation of spacer in new machines
Note: The spacers must only be used with washing machines and tumble dryers manufactured by Asko
Appliances, Sweden.
Instruction
1. Put the spacers on the washing
machine. Make sure that the edges
of the spacers are lined up carefully
with the edge of the washing
machine panel.
. Remove the anti-tilt device from
the tumble dryer. This is no longer
needed.
. Open the knockout hole on the
back of the dryer using a hammer
and screwdriver. (You must not
remove it completely, just open it.)
4. Screw out the feet of the tumble
dryer turns from their fully
screwed-in position.
Then lift up the tumble dryer. Put the
back feet of the tumble dryer in the
"keyholes" in the spacer and slide
the tumble dryer backwards. Put the
front feet down in the holes.
5. Remove the two outer screws on
the back of the washing machine so
that you can fit the anti-tilt device.
1
Picture
Advertenties
