Zanussi ZBA15021SA Gebruiksaanwijzing pagina 17
Verberg thumbnails
Zie ook voor ZBA15021SA:
- Gebruiksaanwijzing (40 pagina's) ,
- Gebruiksaanwijzing (45 pagina's) ,
- Gebruiksaanwijzing (41 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on the
ground.
The temperature in the ap-
pliance is too low.
The temperature in the ap-
pliance is too high.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
At the same time,
with the fingers ex-
pand up and down
the transparent cover
and unhook it in the
direction of the ar-
rows.
Replace the lamp
with one of the same
power and shape,
specifically designed
for household appli-
ances. (the maximum
power is shown on
the light bulb cover).
Reassemble the
lamp cover.
Connect the plug to
the mains socket.
Open the door. Make
sure that the light
comes on.
www.zanussi.com
All manuals and user guides at all-guides.com
Possible cause
During the automatic defrosting
process, frost defrosts on the rear
plate.
The water outlet is clogged.
Products prevent that water flows
into the water collector.
The melting water outlet does not
flow in the evaporative tray above
the compressor.
The temperature regulator is not
set correctly.
The temperature regulator is not
set correctly.
1
2
1
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Solution
17
Advertenties
Hoofdstukken
Inhoudsopgave
