Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Troubleshooting
Troubleshooting
Problem
Motor is not functioning,
transmission control
light is not lit
Motor is not functioning,
transmission control
light is lit
Transmission control light
and the word BATTERY
is displayed
The transmitter does not
react after the batteries
have been changed
The automatic
switching commands
are not executed
The system is not extended
automatically when the
sliding switch is set to 'Auto' Wind speed exceeds
The system extends
manually for just 2 sec. and
immediately retracts with
sliding switch setting 'Man'
or 'Auto'
The system extends
manually for just 4 sec. and
immediately retracts with
sliding switch setting 'Man'
or 'Auto'
All manuals and user guides at all-guides.com
Cause
Batteries are dead
Batteries are
incorrectly inserted
Receiver outside the
radio range
Transmitter is not
programmed in the receiver
Batteries are running out
Power supply has been
interrupted for too long
The sliding switch is
on manual
Sunlight intensity is below
the threshold value
the threshold value
The curtain is not in the
upper end limit
The intermediate position
is in the upper end limit
Wind speed exceeds
the threshold value
The Radio link between
the sensor and the receiver
has been interrupted;
check the transmission path Reduce distance between
by actuating the
UP/STOP/DOWN button
at the sensor
83
Solution
Insert new batteries
Insert batteries correctly
Reduce distance to
the receiver
Programme transmitter
Insert new batteries
Press the RESET button,
check settings
Move the sliding switch
to automatic
Adjust sun threshold value
Wait until wind abates
Manually move the awning
to the upper end limit
Reprogram the
intermediate position
Wait until wind abates
(min. 15 minutes)
Re-establish the radio link
Check power supply
to the sensor
the sensor and receiver
GB
Advertenties
Hoofdstukken
Inhoudsopgave
