Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Charging mobile devices
• Connect the USB-A connector of the included USB charging cable to the USB-A output (5).
• Connect the Micro USB connector of the USB charging cable to your mobile device. The
charging process commences.
• The remaining capacity of the battery is indicated by brief successive flashing of the battery
level indicator, as described in section "Charging the internal battery".
• Monitor the charging process. Remove the USB cable from the product and the mobile
device as soon as the charging process is complete.
If the internal battery charge level becomes too low, the product will turn off
automatically to prevent excessive discharge of the internal battery.
LED torch
• To turn on the torch, press the function switch (2).
• Then briefly press the function switch to change the lighting mode. The torch toggles in the
following order:
Solid bright light → solid dimmed light → flashing light → light off
• To turn on the SOS signal, press and hold down the function switch for approx. 3 seconds. The
solid bright light will turn on at once. The lighting mode will change after approx. 3 seconds and
will then show an SOS signal.
• Briefly press the function switch to turn off the torch directly again.
Eyelet for hand strap
• You can attach the included hand strap to the eyelet (4), if necessary.
• You can also use a suitable hook to hang the product. Make sure that the product does not
fall.
Care and Cleaning
• Disconnect the product from the connected devices before cleaning.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these could
damage the housing or stop the product from functioning properly.
• This product does not contain any components that require maintenance. Never attempt to
open or disassemble it.
• Use a lint-free cloth to clean the product. Do not press too hard on the housing, as this can
lead to scratch marks.
• Dust can be easily removed using a soft and clean long-haired brush.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product according to
the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to protection of the
environment.
Technical data
Input voltage/current ..................... Micro USB: 5 V/DC 0.8 A
Output voltage/current .................. USB-A: 5 V/DC 1 A
Battery .......................................... Li-ion type 18650, 3000 mAh
LED torch ..................................... Colour temperature 6000 – 6500 K
Luminous flux ............................... 120 lm
Operating/storage conditions ........ 0 to +45 °C, max. 85 % RH (non-condensing)
Dimensions (L x Ø) ....................... 111 x 23 mm
Weight .......................................... 64 g
All manuals and user guides at all-guides.com
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
Copyright 2018 by Conrad Electronic SE.
*1694985_v2_0818_02_hk_m_en
Advertenties
Inhoudsopgave
