Advertenties
Beschikbare talen
Beschikbare talen
Operating Instructions
Rechargeable LED Work-
light
Item No. 2522106
Intended use
The product is intended to be used as a work light.
It has three light settings, and a USB-A output for
charging mobile devices.
It has an ingress protection rating of IP64 which
means it is dust tight and can resist water splashing
from all directions.
For safety and approval purposes, you must not
rebuild and/or modify this product. If you use the
product for purposes other than those described
above, the product may be damaged. In addition,
improper use can result in other hazards. Read the
instructions carefully and store them in a safe place.
Make this product available to third parties only
together with its operating instructions.
This product complies with the statutory national and
European requirements. All company names and
product names are trademarks of their respective
owners. All rights reserved.
Delivery content
•
Unit
•
Charging cable
•
Operating instructions
Up-to-date operating instructions
Download the latest operating instructions at www.
conrad.com/downloads or scan the QR code shown.
Follow the instructions on the website.
Explanation of symbols
The symbol with the exclamation
mark in the triangle is used to indicate
important
information
in
operating instructions. Always read this
information carefully.
The arrow symbol indicates special
information and advice on operation.
This device was constructed according
to protection class III. Protection class
III includes electrical devices with a
low voltage power supply (< 50 volts)
using a safety transformer or batteries/
rechargeable
batteries/solar
etc. Devices in protection class III have
no connection for protective insulation
- they must not be connected to the
protective earth.
Operating elements
1 Bracket (foldout 180º)
3 Cover (in open position)
2 Power button
4 USB-A output
High → low → warning light
5 Charging device indicator
(flashing red) → OFF
(green)
Safety instructions
Read the operating instructions
carefully and especially observe
the safety information. If you do not
follow the safety instructions and
information on proper handling in
this manual, we assume no liability
for any resulting personal injury or
damage to property. Such cases will
invalidate the warranty/guarantee.
a) General information
•
The device is not a toy. Keep it out of the reach
of children and pets.
•
Do not leave packaging material lying around
carelessly. This may become dangerous playing
material for children.
•
Protect the appliance from extreme tempera-
tures, direct sunlight, strong jolts, flammable
gases, steam and solvents.
•
Do not place the product under any mechanical
stress.
•
If it is no longer possible to operate the product
safely, take it out of operation and protect it from
any accidental use. Safe operation can no longer
be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor
ambient conditions or
- has been subjected to any serious transport-
related stresses.
•
Please handle the product carefully. Jolts, im-
pacts or a fall even from a low height can dam-
age the product.
•
Consult an expert when in doubt about the op-
eration, safety or connection of the appliance.
•
Maintenance, modifications and repairs must
only be completed by a technician or an author-
ised repair centre.
•
Make sure the specifications of any connected
these
device conform to the product specifications
listed in the technical data section.
•
Do not short-circuit the USB input (7).
•
If you have questions which remain unanswered
by these operating instructions, contact our tech-
nical support service or other technical person-
nel.
b) Connected devices
•
Also observe the safety and operating instruc-
tions of any other devices which are connected
energy
to the product.
c) LED light
•
Attention, LED light:
- Do not look directly into the LED light!
- Do not look into the beam directly or with opti-
cal instruments!
1
2
3
6 Charging battery indicator:
Charging (flashing red)
Fully charged (solid red)
7 Micro USB charging input
Operation
Before connecting, make sure that the USB power source can deliver sufficient current,
otherwise you may damage the source. Do not use a USB port of a computer, keyboard or USB
hub without a power adapter as the current supplied by these ports is insufficient.
Looking into an LED light in darkness can cause temporarily blindness. This can be dangerous
in high risk environments.
To protect the IP64 rating, check that the cover (3) forms a good seal when closed.
Risk of overheating. Do not connect any devices to the USB-A output (4) while the device is
charging.
a) Work light
•
Press the power button (2) repeatedly to cycle between light modes: High → low → warning light
(flashing red) → OFF.
•
The worklight will turn off when the battery needs to be recharged. Recharge it by connecting one end of
the included charging cable to the Micro USB charging input (7), and the other end to a suitable power
supply.
b) Power bank
•
Connect your mobile device to the USB-A output (4).
Charging will begin automatically on connection, and the charging device indicator (5) will light red.
•
Care and cleaning
•
Disconnect the product, turn the light off, and allow to cool down before each cleaning.
•
Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as they can
cause damage to the housing and malfunctioning.
•
Clean the product with a dry, fibre-free cloth.
Disposal
This symbol must appear on any electrical and electronic equipment placed on the EU market.
This symbol indicates that this device should not be disposed of as unsorted municipal waste
at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it separately
from unsorted municipal waste. Spent batteries and accumulators, which are not enclosed by
the WEEE, as well as lamps that can be removed from the WEEE in a non-destructive manner,
must be removed by end users from the WEEE in a non-destructive manner before it is handed
over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste.
Conrad provides the following return options free of charge (more details on our website):
•
in our Conrad offices
•
at the Conrad collection points
•
at the collection points of public waste management authorities or the collection points set up by manu-
facturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in countries
outside of Germany.
Technical data
This product contains a light source of energy efficiency class F.
Battery .................................................. Li-ion 4400 mAh (2 x 2200 mAh, 16.28 Wh)
Battery recharge ................................... approx. 7 hrs
Input voltage / current ........................... 5 V/DC / max. 1 A (via micro USB)
Output voltage / current ........................ 5 V/DC / 1 A (via USB-A)
Colour temperature ............................... 6500 K (low and high mode)
Brightness ............................................. 1100 lm (high mode), 150 lm (low mode)
Power ................................................... 10 W (high), 3 W (low)
Runtime (approx.) ................................. 2.5 hrs (high), 8 hrs (low), 24 hrs (flashing)
Material ................................................. ABS, aluminium
Ingress protection ................................. IP64
Bracket ................................................. 180º
Protection class .................................... III
Operating/Storage conditions ............... -20 to +45 ºC
Cable .................................................... Micro USB to USB-A (30 cm)
Dimensions ........................................... 160 x 118 x 48 mm (W x H x D)
Weight .................................................. 3 68 g
4
5
6
7
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights
including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represent the technical status at the time of printing.
Copyright 2023 by Conrad Electronic SE.
*2522106_v3_0223_02_dh_mh_en
Advertenties
