Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
DIAMOND3
•
Fit the saw blade on the centre ring of
the motor flange . (Check the direction
of rotation and make sure the blade is
well centred.)
•
Mount saw flange and tighten with the
hexagon nut .
VARIOUS SAWING
PROCESSES
One-step sawing
(Use only original saw blades as advised
by the manufacturer)
•
Move saw head down until the saw is
approx . 10 mm . below the saw table .
•
Secure saw head with the knob .
•
Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop .
•
Hold material to be cut with one hand
while making sure your hand is not to
close to the saw blade .
•
Pull the saw head with medium force
with the other hand through the
material .
Multiple-step sawing
During this sawing process the saw is
positioned at the desired height and
moved back and forth through the material
to be cut until after a number of steps it is
completely cut through .
•
Place the material to be cut on the
sawing table and position against the
350 RS SERIES
®
fixed stop and eventually the adjust-
able stop .
•
Position the saw head at the desired
height .
•
Hold material to be cut with one hand
while making sure your hand is not to
close to the saw blade .
•
Switch the machine on and pull the
saw head with medium force with the
other hand through the material .
SAFETY
In addition to the valid safety regulations
attention to the following items should be
made:
•
Carefully follow the directions of set-
ting up and working with the sawing
machine .
•
Carefully check that the electrical con-
nections are correct .
•
Electrical cables should not come in
contact with water or water spray .
•
Damaged saw blades should be
replaced immediately .
•
Secure material to be cut by hand dur-
ing sawing .
•
Make sure your hands stay away as
far as possible from the rotating saw
blade .
•
Wear protective goggles during
sawing .
•
Wear hearing protection during
sawing .
MAINTENANCE
•
The cooling water should be replaced
and/or replenished regularly .
•
It is recommended to clean the water
container, pump, hoses and spray noz-
zle on a regular basis . For example,
place the pomp in a bucket of clean
water after the sawing job and run the
machine for a minute or so . This also
19
GB
Advertenties
Hoofdstukken
Inhoudsopgave
