Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
CONTRÔLEUR EASILED 12-24 5 CANAUX
CODE : 45190
WARNING: The installation must be carried out by qualified persons in accordance with the standards and regulations in force. It is recalled that the decision to install the products in an environment compatible and in compliance with the standards and good practices is the full responsibility of the
EN
buyer and the installer. Read and follow the instructions before installing, powering on or using the products. We do not accept any liability resulting from improper implementation or installation of the products.
The devices must not be modified, even partially, otherwise the warranty will not apply.
IMPORTANT: Always turn off the power to the network before each installation or maintenance operation.
Master/slave jack plug
Master Slave
5-channel RF controller
Pairing
Synchronisation signal
Pairing:
Input/output
Pairing of remote controls
1. TECHNICAL SPECIFICATIONS
Purpose: Controller for monochrome, TW, RGB, RGBW and RGB+TW LED devices: dimming,
changing colour temperature and LED colour.
Input voltage: 12VDC/24VDC
Material: plastic
Max. power per channel: 12 VDC = 5 x 60 W, 24 VDC = 5 x 120 W
Communication interface: via EASi LED MASTER REMOTE remote control, master/slave via
HF radio link
Operating temperatures: -20°C / +50°C
2. CONTENTS
x1 controller
3. PRECAUTIONS BEFORE INSTALLATION
Do not install the device while it is switched on.
Do not expose the device to humidity.
4. INSTALLATION
A - Pairing
Wire the RF receiver correctly for your installation and switch it on.
Pairing the RF receiver with the RF remote control: please refer to the instructions of the remote
you want to pair it with.
B - Clearing the pairing
Wire the RF receiver correctly for your installation and switch it on.
Press the 'Pairing' button on the receiver and hold it down for at least 5 seconds until the
connected LED product flashes once and stays on 100% on all channels, which means the
pairing has been deleted.
Master/slave jack plug:
One 'master' can connect to multiple 'slaves' to achieve perfect synchronisation. The synchroni-
sation distance can be up to 50m without any voltage drop.
NB: pairing with a remote control is not possible in 'slave' mode
NB2: - 1 receiver can only be paired with a maximum of 8 different remote controls.
5. CABLING DIAGRAM
If the charging current exceeds 20A
DC power supply
Common anode (+) LED output
Channel 1: Red channel (-)
Channel 2: Green channel (-)
Channel 3: Blue channel (-)
Channel 4: Warm white channel (-)
Channel 5: Cold white channel (-)
Master
Slave
Slave
EUROPOLE - 19, avenue ZAC de Chassagne - 69360 TERNAY - Fax : +33 (0)4 72 24 73 42 - www.europole.net
12V/24V/36V
power supply
12V/24V/36V
power supply
12V/24V/36V
power supply
3
Advertenties
Inhoudsopgave
