Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
TÉLÉCOMMANDE EASILED MASTER
REMOTE HF RGB+TW 4 ZONES
CODE : 45234
WARNING: The installation must be carried out by qualified persons in accordance with the standards and regulations in force. It is recalled that the decision to install the products in an environment compatible and in compliance with the standards and good practices is the full responsibility of the
EN
buyer and the installer. Read and follow the instructions before installing, powering on or using the products. We do not accept any liability resulting from improper implementation or installation of the products.
The devices must not be modified, even partially, otherwise the warranty will not apply.
Touch or slide your finger across the touch bar to switch
on the dynamic white part of the controller and vary the
white temperature
Press and hold to increase or decrease the light intensity
of the RGB part of the controller
Click to switch all zones on/off
Slide your finger on the colour wheel to change colour
Play/Pause button: play/pause one of the 10 pre-re-
corded scenarios. Press and hold to increase/decrease
scrolling speed
Select the desired zone by pressing one of the keys.
Press and hold to switch the zone on/off
Press to switch channels R (red), G (green), B (blue) on/
off. Hold to vary the intensity of the channel
Hold to save a setting.
Press to recall it
1. TECHNICAL SPECIFICATIONS
Purpose: Remote control for RGB+TW LED products: dimming, changing colour temperature and colour, cycling.
Number of independent zones: 4
Number of channels: 5
Signal transmission: HF radio 868/869.5/434MHz
IP code: IP20
Protocol used: EASILED RF
Material: plastic
Operating temperatures: 0°C/+40°C
Further information: Compatible with EASi LED controllers.
2. CONTENTS
x1 remote control
x1 wall bracket
3. PRECAUTIONS BEFORE INSTALLATION
This device contains AAA batteries which must be stored and disposed of properly.
Do not expose the device to humidity.
Press to play your next program
4 different modes: Jump, Flash, Fade, Blink
Programming button
Hold to increase/decrease the brightness of the dynamic
white part
EUROPOLE - 19, avenue ZAC de Chassagne - 69360 TERNAY - Fax : +33 (0)4 72 24 73 42 - www.europole.net
4. ADJUSTING THE SETTINGS
Pairing (method 1)
Step 1: Make sure you have the controller wired and switched on,
connected to a compatible LED product
Step 2: Switch on the remote control using the central button
Pairing
Step 3: Press the pairing button on the controller
Step 5: Adjust the colour wheel.
The product LED should flash, then respond to the command
Step 4: Press the desired pairing zone
Pairing (method 2)
Step 1: Make sure you have the controller wired and switched on,
connected to a compatible LED product
Step 2: Switch on the remote control using the central button
Pairing
Step 3: Press the pairing button on the controller
Étape 4 : Press the desired pairing zone twice, then hold it down.
Holding must take place within 10 seconds after the double click.
If the operation is valid, the LED product connected to the paired
controller will flash once.
NB: If using multiple controllers, you can either:
- Pair all controllers on one zone
- Pair different controllers on different zones
EASI LED RECEIVER
EASI LED RECEIVER
3
Advertenties
Inhoudsopgave
