Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
it is correctly destroyed and replaced by an
approved BS 1363/3A fused plug and that the
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue
neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black.
- The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.
TECHNICAL DATA
Mains voltage
Mains frequency
Power input
No-load speed
Sanding surface
Protection class
Weight
NOISE AND VIBRATION
Sound pressure (L
)
pa
Acoustic power (L
)
wa
Uncertainty (K)
Vibration
Uncertainty (K)
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardised test given in EN 60745; it may be used
to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
PSM1024
V~ 230
Hz 50
W 180
min
12,000
-1
mm 187 x 92
IP 20
kg 1.42
PSM1024
dB(A) 76
dB(A) 90
dB(A) 3
m/s
6.4
2
m/s
1.5
2
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCrIPTIOn (fIg. A)
Your finishing sander has been designed for
sanding wood, metal, plastics and painted
surfaces.
1. On/off switch
2. Lock-on button
3. Sanding pad
4. Sanding paper clamp
5. Grip
6. Dust extraction connection
ASSEMBLy
4
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Mounting and removing the sanding paper
(hook-and-loop system) (fig. B)
Mounting
● Mount sanding paper (7) with the required
grain size onto the sanding pad (3). Make sure
that the perforation in the sanding paper (7)
corresponds with the perforation on the
sanding pad (3).
removing
● Remove the sanding paper (7) from the
sanding pad (3).
Mounting and removing the sanding paper
(sanding paper clamps) (fig. C)
Mounting
● Open the sanding paper clamps (4).
● Mount sanding paper (7) with the required
grain size onto the sanding pad (3). Make sure
that the perforation in the sanding paper (7)
corresponds with the perforation on the
sanding pad (3).
● Fold the sanding paper (7) at both ends
around the edges of the sanding pad (3).
● Close the sanding paper clamps (4) one by
one. Make sure that the ends of the sanding
paper (7) are clamped.
5
Advertenties
Inhoudsopgave
