Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
MALFUNCTIONS
Troubleshooting table
If you are uncertain about whether your appliance is functioning properly, this does not
automatically mean there is a defect. Try to deal with the problem yourself first by checking the
points mentioned below in the table or visit our website 'www.Pelgrim.nl' for more information.
Problem with the hob
The fan runs on for several
minutes after the hob has been
switched off.
A slight smell is noticeable the
first few times the hob is used.
The pans make a noise while
cooking.
You have switched on
a cooking zone, but the display
keeps flashing.
A cooking zone suddenly
stops working and you hear
a signal.
The hob is not working and
nothing appears in the display.
A fuse blows as soon as the
hob is switched on.
Fault code F and C.
Other error codes
EN 18
Possible cause
The hob is cooling down.
The new appliance is
heating up.
This is caused by the energy
flowing from the hob to the
saucepan.
The pan used is not suitable
for induction cooking.
The preset time has ended.
There is no power supply due
to a defective cable or a faulty
connection.
The appliance is incorrectly
connected.
Appliance overheated.
Defective generator.
Solution
Normal operation.
This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
This is normal for certain
saucepans, particularly at
high settings. This does not
harm the pans or the hob.
Use a good pan.
Press any button to switch off
the signal.
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
Let the appliance cool down
and then start again.
Contact your service centre.
Advertenties
Hoofdstukken
Inhoudsopgave
