Advertenties
Beschikbare talen
Beschikbare talen
Washing dishes
Programme selection
The most appropriate programme can be
identified by comparing the type of
crockery, cutlery, etc., as well as the
amount and condition of food remains,
with the details contained in the
programme overview.
The corresponding programme sequence,
duration and consumption details are
shown in the bottom half of the overview.
For example:
For a mixture of various types of crockery
and utensils with plenty of food remains
that are not stuck on fast, use the
Auto
programme.
Reduce costs!
If only a small number of
dishes have been loaded into
the dishwasher, selecting a
programme that operates at
the next lowest temperature
will usually suffice.
Programme data
The stated programme data are based on
standard operating conditions. The values
can vary considerably according to:
different amounts of dishes
temperature of mains water supply
pressure of mains water supply
ambient temperature
fluctuations in mains voltage
machine-related factors (e.g.
temperature, water volume, ...).
Energy and water consumption is reduced
by up to 1/4 when dishes are washed in
the upper basket only.
Water consumption values are based on a
water hardness setting of 4.
Aquasensor *
* on applicable models
The Aquasensor is an optical measuring
device with which the cloudiness of the
water in the dishwasher is measured. A
photoelectric sensor is used to detect the
degree of soiling in the water, caused by
dissolved food particles such as egg, fat
and rolled oats, etc.
The Aquasensor functions during all
programmes that include a pre-rinse cycle.
If the water is still "clean" at the end of the
pre-rinse cycle, then the same water is
used for the following wash cycle. If the
water is dirty, it is pumped out of the
dishwasher and replaced by fresh water.
The effect is to reduce water consumption
by approx. 5 litres when the dishes are
only "slightly" dirty.
Switching the dishwasher ON
Turn on the tap.
Set main switch
Indicators light up according to the last
programme that was selected.
This same programme will run again if
no other programme button
pressed.
For appliances with top basket feature:
If only the top basket is loaded, press
the top-basket button
The numerical display
expected duration of the programme.
The programme starts automatically.
End of programme
The programme has ended when a figure
appears in the numerical display
en
to ON.
1
is
6
.
5
shows the
3
3
.
39
Advertenties
