Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
1.
Remove the
screw from the
lamp cover.
2.
Remove the
lamp cover (refer
to the illustra-
tion).
3.
Replace the
used lamp with a
new lamp of the same power and specifically de-
Technical data
Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the ener-
gy label.
Installation
Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
22
Possible cause
There is no cold air circulation in the
appliance.
Height
Width
Depth
Make sure that there is cold air circula-
tion in the appliance.
signed for household appliances (the maximum
power is shown on the lamp cover).
4.
Install the lamp cover.
5.
Tighten the screw to the lamp cover.
6.
Connect the plug to the mains socket.
7.
Open the door. Make sure that the light comes on.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "Installa-
tion".
3.
If necessary, replace the defective door gaskets.
Contact the Service Center.
1780 mm
560 mm
550 mm
24 h
230-240 V
50 Hz
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Solution
Advertenties
Hoofdstukken
Inhoudsopgave
