Advertenties
Beschikbare talen
Beschikbare talen
Operation
There are three ways to operate the LED Triple Flex + Strobe:
A. Master/Slave operation
B. Easy sound active and Auto mode
C. With universal DMX controller
Master/Slave operation
The units can be linked together in master/slave mode to perform a great built-in pre-programmed lighting shows or it can be
triggered by music.
In Master/Slave mode refer to the DMX settings below:
Master unit: The master unit must be set to Auto-run or Sound Control mode operation
Slave units: DMX start address MUST be set to 001. (First DIP switch = ON, all others are OFF)
Settings:
Sound active mode: DIP switch 10 = ON , with dip 1 - 6 the speed can be adjusted. All others must be OFF
Auto mode: DIP switch 9 and 10 = ON , with dip 1 - 6 the speed can be adjusted. All others must be OFF
Universal DMX controller
When using a universal DMX controller, you have to set the DMX address by dip switches from 1 to 9 to make sure all the units
will receive the correct DMX signal.
Please refer to the following diagram to know how to address your DMX 512 system in the binary code.
DMX 512 Address Chart:
Dip-switches
# 1
# 2
Value
1
2
DMX Settings
0: OFF 1: ON -: OFF or ON
Function
1
Sound
Auto
DMX512
11～200
Channel 1
201～255 DMX Sound
0～255
Channel 2
0～255
Channel 3
0～255
Channel 4
0～255
Channel 5
0～255
Channel 6
0～255
Channel 7
11～255
Channel 8
Auto-run, Sound Control
Master
Slave
1
# 3
# 4
# 5
# 6
4
8
16
32
DIPSWITCH CHART
2
3
4
5
Speed selection
(Slow→Fast)
SET DMXADDRESS FOR DMX MODE
DMX Auto
No.1 LED Gobo
No.2 LED Gobo
No.3 LED Gobo
No.1 Motor Position
No.1 Motor Position
No.1 Motor Position
Strobe(Fast--Slow)
0
0
0
0
# 7
# 8
# 9
#10
64
128
256
2-light show
6
7
8
9
0
0
0
0
0
1
0
0
0
0
10
1
1
0
0
Advertenties
