Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
22
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the Super, or after
changing the temperature.
Temperature cannot be set.
The temperature in the ap‐
pliance is too low/too high.
Door does not open easily.
All manuals and user guides at all-guides.com
Possible cause
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not wrap‐
ped properly.
Temperature is set incor‐
rectly.
This is normal, no error has
occurred.
The Super function is
switched on.
The temperature regulator is
not set correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The Super function is
switched on.
There is no cold air circula‐
tion in the appliance.
You attempted to re-open
the door immediately after
closing.
Solution
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet‐
ter.
Refer to "Operation" chap‐
ter.
The compressor starts after
a period of time.
Switch off Super manually,
or wait until the function re‐
sets automatically to set the
temperature. Refer to "Su‐
per function"
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Refer to "Super function".
Make sure that there is cold
air circulation in the appli‐
ance.
Wait a few seconds between
closing and re-opening of
the door.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
