Download Print deze pagina

FLINQ FQC8363 Handleiding pagina 4

Advertenties

Beschikbare talen

Beschikbare talen

EN
Manual
- Ensure that the device do not come into contact with heat sources, hot
objects or naked flames.
- Do not attempt to charge the device when the battery is damaged.
- Leaks from battery cells can occur under extreme conditions. If the liquid
gets on the skin, wash it immediately with soap and water. If the liquid gets
into the eyes, flush them directly with clean water for at least 15 minutes
and seek medical attention.
Battery replacement
1. Open the battery compartment door at the middle by using 2 hands and
open it to turn counter-clockwise.
2. Hold the flashlight with the lens upwards and open battery cover when
rotation stops to insert or remove the battery.
3. Clean battery contacts and device contacts before installing the battery.
4. Install the 3.7V 18650 battery and make sure to check the correct polarity
+ and - inside the battery compartment (+ side facing spring side)
5. Close the battery box door by using 2 hands and close it to rotate
clockwise until rotation stops.
6. Make sure it is firmly closed to have it waterproof (IP44).
Read and follow all safety instructions
- This product is suitable for indoor and outdoor use but it's not waterproof
IP-6X, do not submerse under water!
- Please use the rated input voltage power supply of the product as
mentioned on the back label.
- Do not install near a gas device or other sources with a similar heating
process.
- Do not use the product outside its intended use.
There is risk of fire or electric shock, if the battery is replaced by an incorrect
type. Remove the battery from the product if it is not used for a long time (1
month or longer). For best results, you need to replace the battery when the
brightness of the lights decreases and /or when the lights stops working, or
if remote control does not work anymore.
Only use battery of the same type. The battery life is subject to the quality,
brand and the ambient temperature.
The capacity of the battery decline rapidly if the temperature gets below
5 degrees.
Do not put battery into fire, water or high temperatures. Do not open
or damage the battery. Battery may explode, leak or cause damage. If
a battery is swallowed, immediately consult a doctor/medical attention.
Ingestion can cause severe chemical burns in just 2 hours and result in
serious injury or death. If the battery compartment box does not close
securely, stop using the device and keep away from children.
Keep the optional external adapter out of reach of children.
Never charge this product in moisture conditions or in the rain. Only charge
it indoors, in a dry place.
- This is not a TOY, keep away from small children below 12 years.
- Do not open or disassemble the light or adapter yourself, this will void the
warranty at all times.
- Do not disassemble, repair or modify the product by yourself as this may
result into an electric shock.
- Do not look directly into the light beads as it could hurt your eyes.
- The led source is not replaceable.
- If the cable or adapter is damaged or broken please contact your seller for
correct replacement by the manufacturer only.
- Do not stand, sit on, jump or throw with the light at all times.
- Do not throw this product in the air as it may cause damage by falling.
- Only use the light for its intended designed use as a light.
- Take good care of the product and clean it regularly.
- Never touch the plug contacts with sharp or metal objects.
- Use only the original power supply and original accessories.
- Do not use the device outdoors with heavy rain
- Protect the device from special liquids and vapors.
Note
- Please note that the power port of the device should not be infiltrated by
lots of water. Otherwise, it will cause a product failure.
- Do not charge or store the product in a place below 0 or above 40 degrees,
otherwise the product performance will be reduced.
- It is a normal phenomenon that temperature of the adapter rises during
use.
FlinQ Rechargeable LED Flashlight

Advertenties

loading