UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the product be irreparably damaged. The product must also be
directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROL ELEMENTS
1.
Microphone Input
Balanced XLR input jacks.
2.
Insert
6.3mm (¼") jacks can be used to process channel signal with dynamic processors or equalizers.
3.
Line Input
Balanced 6.3mm (¼") jack line inputs. You can connect either balanced or unbalanced phone plugs to these jacks.
4.
Line Input CH6/7
6.3mm (¼") jacks for the left and rights sides of the stereo channels, which can be used in parallel.
5.
Tape Input
These RCA jacks input for stereo sound source. Use this jacks when you want to connect a CD player directly to the
mixer.
6.
REC Output
These RCA jacks can be connected to an external recorder.
7.
Headphone
6.3mm (¼") jack for connecting a headphone.
8.
Main Output
6.3mm (¼") deliver the mixer's stereo output. You use these jacks, for example, to connect to the power amplifier
driving your main speakers.
9.
USB Port
Put the USB-disk into this port.
10. Aux Send
The Aux send jack carries the master aux mix (from the channel's Aux controls).
11. Gain Control
4