Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
Set the oven function selector knob and
the temperature selector knob in off posi-
tion.,
Touch and hold < / > or
alarm. The
and
display will show the current time after
approximately 7 seconds.
Delayed timed operation
In order to set the appliance to switch off at a
specific time after a set Duration has elapsed,
set the Duration and the End Time:
repeatedly until the display
Touch
MENU
shows dur (duration) briefly and the
symbol will be flashing,
set the desired duration from 1 minute to
10 hours using the
< / >sensors,
repeatedly until the display
Touch
MENU
shows End briefly and the
be flashing,
set the End Time using the < / >, sensors,
a maximum of 23 hours and 59 minutes
ahead,
set the function selector knob and the
temperature selector knob to preferred
settings. The
active. The appliance will switch on at
End Time minus Duration (i.e. if the set
Duration is 1 hour and the set End Time
is 14:00, the appliance will automatically
switch on at 13:00).
Once the Duration time has elapsed the oven
will turn off automatically. You will hear an
alarm and the
and
Set the oven function selector knob and
the temperature selector knob in off posi-
tion.,
Touch and hold < / > or
alarm. The
and
display will show the current time after
approximately 7 seconds.
to mute the
MENU
will be off and the
symbol will
and
functions are now
will be flashing,
to mute the
MENU
will be off and the
Cancel settings
Timer and delayed timed function settings
may be cancelled at any time.
Cancel automatic function settings:
simultaneously touch the < / >, sensors
Cancel timer settings:
Touch the
MENU
Kitchen Timer,
simultaneously touch the < / > sensors
Change the beep tone
You can change the beep tones as follows:
simultaneously touch the < / >, sensors
Touch
MENU
(tone). The display will be flashing:
Use the < / > sensors to select your pre-
ferred tone:
Use > to select the setting 1 to 3
Use < to select the setting 3 to 1
Adjust display brightness
You can adjust display brightness 1 to 9,
where 1 is the darkest and 9 is the brightest.
The brightness setting applies to an inac-
tive control panel, i.e. when no controls are
touched for 7 seconds.
You can adjust display brightness as follows:
Simultaneously touch the < / > sensors,
Touch
MENU
(brightness) setting — the settings can
be accessed in sequence ton (tone) and
bri (brightness).
Use the < / > sensors to select your pre-
ferred brightness:
Use > to select the setting 1 to 9
Use < to select the setting 9 to 1
Note:
The display is at its brightest setting when
active, i.e. a control was touched within the
last 7 seconds.
Night Mode
The display is dimmed during the night hours
22:00 — 06:00.
22
sensor to select the
repeatedly to select the ton
repeatedly to select the bri
Advertenties
Hoofdstukken
Inhoudsopgave
