Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
The compressor does not
start immediately after press-
ing the FastFreeze, or after
changing the temperature.
The compressor does not
start immediately after press-
ing the Shopping, or after
changing the temperature.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis-
play.
The temperature in the appli-
ance is too low/too high.
Possible cause
This is normal, no error has
occurred.
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
The FastFreeze or Shop-
ping function is switched
on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
Solution
The compressor starts after a
period of time.
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off FastFreeze or Shop-
ping manually, or wait until the
function resets automatically to
set the temperature. Refer to
"FastFreeze or Shopping func-
tion".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and display
shuts off for a short time.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
35
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
