Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Danger of crushed fingers!
• When raising or lowering the seat, be sure to
keep your hands away from the side frames
and swivel arms!
• Keep hands away from the shearing area
unless the product is fully adjusted to the lying
position.
• Do not reach underneath the product when
lying on it. There is a risk of fingers being
crushed by the middle rollers.
Preventing damage to the
product!
• Keep the product away from open flames; the
product is flammable.
Assembly
1. Remove all packaging materials from the
product and place the individual parts on a
clean and level floor (warning: hard surfaces
may scratch the product!).
2. Place the middle frame (2) and the lower
frame (3) on the floor with the pads facing
upwards (Fig. B).
3. Slide the middle frame between the lower
frame and pull out the locking pin (3a) of the
lower frame completely.
4. Position the middle frame so that the locking pin
can engage in the locking hole (2a) of the mid-
dle frame and release the locking pin (Fig. B).
5. Attach both frames as shown in Fig. B.
6. Turn the connected frames over so that the
bottom is on top, slide the top frame (1) to the
middle frame and attach it (Fig. C).
7. Attach the rollers (4) as shown in Fig. D.
Note: use the spanner (8) to counter the rollers.
8. Check that all the screw connections are tight,
and tighten them when necessary.
Use
You can use the product as a rolling board or a
stool.
6
GB/IE/NI
Using the product as a stool
Proceed as follows to use the product as a stool:
1. Pull out the locking pin (3a) of the lower frame
(3) as far as possible and do not let go.
2. Fold the middle frame (2) far up and release
the locking pin so that it engages in the lock-
ing hook (2b) of the middle frame (Fig. E).
3. Fold the upper frame (1) into a horizontal
position (Fig. F).
Using the product as a rolling board
To use the product as a rolling board, proceed in
reverse order as described in the section "Using
the product as a stool".
Maintenance
Regularly check the tightness of all screw con-
nections and tighten them if necessary.
Storage, cleaning
When not in use, always store the product clean
and dry at room temperature. Store the product
in the position as a stool and place it on its side
to prevent it from rolling away unintentionally.
Clean only with water and a mild detergent, and
wipe dry afterwards with a cloth.
IMPORTANT! Never clean the product with
harsh cleaning agents.
Disposal
Dispose of the product and packaging
materials in accordance with current
local regulations. Store the packaging
materials (foil bags, for example) out of
the reach of children. For further information
about disposal of the product no longer needed,
contact your local council. Dispose of the
product and the packaging in an environmenta-
lly friendly manner.
The Recycling Code distinguishes
different materials to be returned for
recycling. The Code consists of the
recycling symbol for the recycling process and a
number that identifies the material.
Advertenties
Inhoudsopgave
