Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
TOUCH SCREEN CONTROLLER INSTRUCTIONS
7. Parameters setting: Keep pressing the MODE button for 6 seconds, after buzzing to enter the parameter
setting interface.
After entering the parameter setting interface, press SET button shortly to change the parameter number,
every pressing will make parameter value +1 (until number 24 then repeat again). After choosing the cor-
rect parameter number, press Mode button for short, parameter value flashes at the top right corner, at this
time to change the value by UP and DOWN buttons. After parameters setting then press SET button to
save.
Attention:
1) After parameters setting, system need around 15 seconds to record, during this period power should not
be off.
2) Please refer to below valid parameters table to set the suitable parameters according to different
requests.
No.
Contents
00
Power to auto restart
01
Electrical heater available
02
Bypass opening
temperature X
03
Bypass opening
temperature range Y
04
Defrosting interval
05
Defrosting entering temperature
06
Defrosting duration time
07
CO2 sensor function value
0 = No CO2 sensor
80 = 800 ppm, 250 = 2500 ppm
Advised setting = 1000 ppm
08
ModBus address
21
ERV models match/
selection
23
Fan speed control
24
Multifunction setting
25
Filter alarm setting
20
Get In Touch
Call: 0845 6880112
Email: info@adremit.co.uk
Range
Default
0-1
0-1
5-30
2-15
15-99
-9-5
2-20
0 / 80-250
1-16
0-15
0: 2 speeds
1: 3 speeds
2: 10 speeds (DC)
0: Reserved
1: Sweep filter alarm
2: sweep weekly timer
0: 45 days
1: 60 days
2: 90 days
3: 180 days
Our Address
Puravent, Adremit Limited, Unit 5a, Commercial Yard,
Settle, North Yorkshire, BD24 9RH
Unit
Record Position
1
Main control
0
Main control
19
°C
Main control
3
°C
Main control
30
Minute
Main control
-1
°C
Main control
10
Minute
Main control
0
PPM
Main control
1
Main control
Main control
2
0
0
Advertenties
Inhoudsopgave
