Advertenties
Beschikbare talen
Beschikbare talen
I Relevant technical parameter
Voltage: DC 4.5V
Sensor Distance: 3 – 5 Meter
Sensor Angle: >=60°。
Battery :3*AA (not included)
AUTO light time: ca. 30 Sek.
II Operation instruction
1.
Insert 3pcs AA Mignon batteries.
2.
Check if the light works properly before installing.
3.
Turn the power switch to relevant position.
OFF: The lights will be off
AUTO: The lights will be automatically on when motion is
detected and off after about 30 seconds
ON: The lights will be always on
4.
There are two ways to install the light: by screws or by
Velcro tape (both are included).
A. By screws: First, fix the hanging board on wall with the
screws. Pay attention that the side with words should
face outward. Then slide the light into the hanging board
and lock the light with the board.
B. By Velcro tape: First fix one of the Velcro tape on the
wall and the other one on the hanging board. Then stick
the two tapes together so that the hanging board is fixed
on the wall. At last slide the light into the hanging board
and lock the light with the board.
III Attention
Put the sensor lamp in your bedroom, kitchen, closet, walkway, corridors, gate, etc.
The best hanging height of the sensor lamp is 1.2-1.5 Meters.
Keep it far away from places where the temperature change sensitively such as refrigerator, stove,
air condition etc.
Do not put the lamp face to the window straightly.
The sensitivity of sensor is related to the direction of movement. The best sensitivity is moving in
transverse direction. And the lowest sensitivity is moving in radial direction. So it's critical to seek the
location of installation in order to get to the best sensitivity
Light Bar with 4 Spots
50994
Up and down 90°
up and down90°
GB
swivel 360°
Advertenties
