Samenvatting van Inhoud voor Audipack Pollutio
- Pagina 1 Installation manual Montage handleiding Projector Outdoor Housing. Pollutio – Hurricane – kryo - Saharan © Audipack...
- Pagina 2 Depending on model, the housing can be standing on feet or hanging from indicated mounting points. Afhankelijk van het model, staat de behuizing op voeten of kan de behuizing worden opgehangen aan de aangegeven ophangpunten.
- Pagina 3 Depending on model, the drawer in the housing can be at the top as shown, or at the bottom. If located on the bottom, the doors open downward. Afhankelijk van het model, is de lade bovenin (zoals afgebeeld) of onderin geplaatst.
- Pagina 4 Depending on model, the waterproof cable feedthrough can be located at the top or at the bottom of the housing. (Always plug off non-used feedthroughs) Afhankelijk van het model, is de waterdichte kabeldoorvoer aan de bovenkant of onderkant geplaatst. (altijd nietg ebruikte doorvoeren afdichten) To install cables, unscrew bolts, remove rubber components, place cable in the rubber components and install in reverse order.
- Pagina 5 Depending on used projector model, the position(s) of ventilators, air filters and heating plates can be different as shown. Afhankelijk van de toegepaste projector, kan de positie van de ventilators, lucht fileter en verwarmings elementen afwijken van getoonde afbeelding. Filter(s) Heater(s) Ventilator(s)
- Pagina 6 To replace filters, unscrew thumbscrew, remove retaining bracket and replace filter(s). Re-assemble in reverse order. Om het filter te vervangen, verwijder de bout, verwijder de beugels en vervang filter(s). Monteren in omgekeerde volgorde.
- Pagina 7 Cut replacement filters to same size as the old ones. Snij de filters op de zelfde maat als de oude filters.
- Pagina 8 Mounting brackets dimensions. Steekmaten montage brackets.
- Pagina 9 Foam to seperate hot and cold air flow (if required). Schuim kraag om warme en koude lucht te scheiden (indien nodig). Foam to seperate hot and cold air flow removed. Schuim kraag om warme en koude lucht te scheiden verwijderd.
- Pagina 10 Heating plates and power rail inside housing. Verwarmings elementen en aansluit rail in de behuizing.
- Pagina 11 To access or install projector, open the front, remove thumbscrew and open drawer. To make sure one does not loose the thumbscrew, place in provided nut on the left. Fasten in reverse order when done. ALWAYS LOCK THE DRAWER!! Om toegang tot de projector te krijgen of deze te installeren, dient met de vleugelmoer te verwijderen nadat de deur is geopend.
- Pagina 13 Audipack reserves the right to make changes in specifications and other information contained in this document without prior written notice. The information provided herein is subject to change without notice. In no event shall Audipack be liable for any incidental, special, indirect, or consequential damages whatsoever, including but not limited to lost profits, arising out of or related to this manual or the information contained herein, even if Audipack has been advised of, known, or should have known, the possibility of such damages.