Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLING COSMO ON YOUR HELMET
To assure a perfect fi t between the magnetic base and the helmet, it is strongly
recommended that Cosmo and the helmet be kept in a room at 20°C for 72 hours prior
to installation.
1. Clean the back part of your helmet with the wet wipe
and let dry for 1 minute.
2. Test fi t your Cosmo / magnetic base to your helmet
without removing the fi lm liner covering the adhesive.
3. Now, remove the protective fi lm from the adhesive
on the magnetic base.
4. Position the magnetic base on your helmet and press
down hard for 1 to 2 minutes.
Please note that best adhesion of magnetic base
to helmet is achieved after 24 hours.
5. Now you can attach your Cosmo to the base.
Do not forget to give it one complete charge before
first use.
Copyright Cosmo Connected TM 2017
exe-starter-guide-V2-NL-EN.indd 20-21
CHARGING YOUR COSMO
A fully charged Cosmo Moto has a battery life of about eight (8) hours (in position and
emergency light modes). For charging, remove the device from your helmet, open the
USB port cover, and connect using the cable provided. Charge your Cosmo Moto from a
computer, a powered docking station, or a certifi ed charger. Check the battery charge
using your Cosmo Connected app.
ACTIVATING AND DEACTIVATING YOUR COSMO MOTO
You can start using your Cosmo Moto once it is charged. To activate, you only need to
double tap (tap twice in rapid succession) either end of the housing (causing the light to
become progressively brighter over the space of 2 seconds). To deactivate, repeat the
same action (light becomes progressively dimmer).
Copyright Cosmo Connected TM 2017
18/09/2017 16:58
Advertenties
Inhoudsopgave
