Operation:
1. Connect an external signal source like a CD-layer to LINE IN (12).
2. Connect the device with an electric outlet (220-240VAC / 50Hz), or operate with a fully
charged Battery. It is possible to use the unit while charging the battery.
LINE INPUT (DVD, CD-player etc.):
1. Connect the source (DVD-player, CD-player etc.) to the line input on the rear panel
2. Slide the input Selector to LINE position.
USB/SD/BT:
1. Slide the input Selector select switch to USB position.
2. Press PLAY button, MP3 begin to play.
BT: Visible as BT2101B, no password needed.
MICROPHONE:
1. Inset the microphone to the MIC jack input.
2. Adjust the MIC volume and tone control.
3. Adjust the echo control.
FINAL:
1. Adjust the master VOLUME (11).
2. Adjust the master Equalizer (1) to get the right sound.
WARNING:
Do not turn the volume at max when use this product at public place just like school,
office etc. After long time using the back panel will be hot, do not touch it by hand.
TROUBLE SHOOTING:
Failure
NO POWER
NO SOUND
MICROPHONE NO SOUND
MICROPHONE HOWL
This appliance should not be put into the domestic garbage at the end of its useful life, but
must be disposed of at a central point for recycling of electric and electronic domestic
appliances. This symbol on appliance, instruction manual and packaging puts your attention to
this important issue. The materials used in this appliance can be recycled. By recycling used
domestic appliances you contribute an important push to the protection of our environment.
Ask your local authorities for information regarding the point of recollection.
Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit. This would
also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by inappropriate use or
disrespect of the warnings contained in this manual. Tronios cannot be held responsible for personal injuries caused by a
disrespect of the safety recommendations and warnings. This is also applicable to all damages in whatever form.
Possible cause
The power line is cut off or not connected
No power on the electric outlet
Wrong input, check input selector
The connect line was broken
The volume knob at lowest
The microphone not complete connected
Adjust the microphone volume
Change microphone
The microphone is too close to the speaker
Master volume adjust too big