Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
B
Product usage
Power off the heater
1.
Press the power button
off the heater.
2.
Unplug the power plug and put it away after it has cooled down.
Notes:
•
After pressing the power button
to blow air for 30 seconds, and the display panel shows 30 29 28 ... 0
countdown. When the countdown is over, the heater enters Standby mode.
•
When you use the product for the first time or need to re-plug the power,
check whether the plug and socket fit well.
Checking method: Insert the power plug into the socket and power on the
heater. After about half an hour, power it off and unplug it. Check whether
the pins of the plug are hot to your hands. If the pins are hot (over 50°C),
you must replace the socket to avoid overheating of the socket due to poor
contact. This may burn the plug and even cause a fire.
Main unit control panel
Button icon
Button name
Power button
Mode button
on the control panel or on the remote control unit to power
to power off the heater, the heater continues
LED status
Usage
• Press to power on or enter Standby
Lights up after
mode.
powered on.
• Press to toggle between On mode and
Standby mode.
• When in On mode, press to toggle
between 01 (low heating) and 02 (high
heating). With high heating mode, the
heater reaches your set temperature
Constantly
faster than with low heating mode.
on when the
• When in On mode, press and hold for
power is on.
3 seconds to enter the temperature
setting mode, then press again to set
the temperature. Each press changes
the temperature value in the sequence
of 18°C
23
EN
22°C
26°C
30°C
35°C.
Advertenties
Inhoudsopgave
