Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
fuse of same type and value.
OPERATION:
Connect the passive speaker with the supplied speaker cable to the speaker output connector (8).
WARNING: only connected the original slave speaker on the speaker output terminal!
LINE INPUT (DVD, CD-player etc.): Connect the source (DVD-player, CD-player etc.) to the line input
(10). MICROPHONE: Inset the microphone to the MIC Jack or MIC XLR socket (11) POWER: Connect the
device with an electric outlet (220-240VAC / 50Hz)
Adjust the master VOLUME (8) and the line (4), mic (5) level to get the right sound balance.
Adjust the tone control (2+3) to get the right sound.
T
his appliance should not be put into the domestic garbage at the end of its useful life, but must be disposed of at a central
point for recycling of electric and electronic domestic appliances. This symbol on appliance, instruction manual and
packaging puts your attention to this important issue. The materials used in this appliance can be recycled. By recycling used
domestic appliances you contribute an important push to the protection of our environment. Ask your local authorities for
information regarding the point of recollection.
Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit. This would also
invalid your warranty. The warranty is not applicable in case of accidents or damages caused by inappropriate use or disrespect of
the warnings contained in this manual. Tronios cannot be held responsible for personal injuries caused by a disrespect of the safety
recommendations and warnings. This is also applicable to all damages in whatever form.
ABS ACTIEVE PA LUIDSPREKERS
Hartelijk dank voor de aanschaf van onze SkyTec actieve luidspreker.
Lees deze gebruiksaanwijzing aandachtig door alvorens het apparaat in bedrijf te stellen.
NEEM VOOR EEN LANGDURIG EN VEILIG GEBRUIK DE VOLGENDE PUNTEN IN ACHT:
1.
Volume control for the output
2.
3.
4.
Volume control for the line input
5.
Volume control for the microphone
6.
Clip indication. These LED will light up when amplifier are
on max power. It can occur that these LED will lit up now
and then, this is not a problem. But if it lights up continually you
need to adjust the volume down, otherwise permanent damage to
equipment might occur
7.
Power Indication. This clear green indicator will light when
the amplifier is turned on.
8.
9.
Output connector (line out). For connection to a second
active speaker box.
10. Line input for audio input source e.g. mixer, CD player, etc
11. Microphone input
12. On/Off Switch: For switching the speaker on and off. Always
adjust the volume down to its minimum before switching this
13. Mains Power Connector / Fuse. This main fuse secures the
speaker against defects. Replace this only with a
Treble tone control
Bass tone control
Speaker output
speaker on.
4 - 12
Advertenties
Inhoudsopgave
