• Keep oven gloves or oven cloths away from the flame.
• Always raise the cover when using the stove.
•
Ensure that all burners are switched off and have cooled down
before closing the cover.
• If there is water on the cover, dry it before opening. If you fail to do so,
moisture may enter the cooker.
• Do not use the decorative cover as a cooking surface.
• The appliance should only be connected by a registered installer.
• Faulty parts may only be replaced by original parts. The manufacturer
can only guarantee that original parts meet safety requirements.
• If the connecting cable is damaged, it may only be replaced by the
manufacturer, the manufacturer's service organisation or equivalently
qualified persons, in order to avoid dangerous situations.
• The appliance should not be connected to the network via a multi-
plug socket or extension lead, as the safe use of the appliance can
then not be guaranteed.
• The appliance must always be earthed.
• The walls and the worktop surrounding the appliance must be heat
resistant up to at least 85°C. Even though the appliance itself does not
get hot, the heat of a hot pan could discolour or deform the wall.
• Failure to maintain the cooker clean could lead to deterioration of
the surface that could adversely affect the life of the appliance and
possible result in a hazardous situation.
• The appliance is not intended to be operated by means of an external
timer or separate remote-control system.
• Before plugging into a socket, check that the voltage in your home
corresponds with the voltage printed on the appliance.
• The safety during use can only be guaranteed when the cooker is
installed correctly and according to the regulations. The installer is
responsible for any damage caused by a faulty installation.
• The gas connection must comply with the national and local safety
regulations. The gas connection must be made by qualified installer.
• The electrical connection must be made by a qualified electricien.
This person is aware of the national and local regulations the
installation must comply with.
• The appliance falls under protection class I and can only be used
in combination with a grounding conductor connection. The
manufacturer accepts no responsibility for any malfunction or
damage caused by incorrect electrical installations.
• The appliance must be connected to a fixed installation and the
means of disconnecting it from the fixed installation must be installed
according to the installation instructions.
19
English
•