Gerelateerde Handleidingen voor Audipack FFCL Series
Samenvatting van Inhoud voor Audipack FFCL Series
- Pagina 1 Flat Panel Fold down Ceiling Lift Flat Panel Fold down Ceiling Lift Installation manual Montage handleiding FFCL-XXXX Model range 2022 © Audipack...
-
Pagina 2: Ceiling Lift Inner Cover Plate (Without False Ceiling)
CEILING LIFT INNER COVER PLATE (without false ceiling) Remove the lift from the packaging. Install it to the ceiling with all applied ceiling mounting points. (amount of mounting points can vary according the model). Use at least M8 mounting bolts Verwijder het product uit de verpakking. - Pagina 3 When the lift is installed, be sure to keep free adjustment space X between the lift and the ceiling to allow a perfect alignment with the false ceiling. Als de lift geïnstalleerd wordt, zorg voor voldoende afstand X tussen plafond en lift voor stelruimte.
- Pagina 4 Before activating the lift be sure the lift is free from abstacles like stairs etc. Plug in the power cord and open the PCB box. Inside the PCB box 2 black buttons are visible and ready to use for opening the lift.
- Pagina 5 When the lift is installed and fully openened, the TV and cables can be installed. Remove the cover panel by pulling it away; it is fastened with magnets. Als de lift is geïnstalleerd en volledig is geopend, kunnen TV en kabels worden aangebracht.
- Pagina 6 When the lift is installed and fully openened, the TV and cables can be installed. By simply lifting the top cover (inside the lift) there is generous acces to install and guide screen cables and guide them to the back of the lift. Fasten cables to the brackets.
- Pagina 7 The TV can be installed via the back of the lift using the standard VESA mounting interface. Drilling extra holes in the lift for specific patterns is no problem. Attention: Be aware of the max. allowed thickness of the screen in the lift De TV kan geïnstalleerd worden via de achterzijde van de lift gebruikmakend van de VESA montagegaten.
- Pagina 8 The closing and opening angle of the lift is adjustable. Open the inside hatch of the lift. 2 adjustable switches are there to be set. Be informed that every adjustment must be made in small steps; check ceiling panels that they are free from rotating. De open en gesloten positie van de lift kunnen worden ingesteld.
- Pagina 9 A ceiling finishing panel can be attached to the back of the lift. • Ceiling panel size = panel height + 87 mm • Ceiling panel width = max. panel width of the lift Een plafondafwerkplaat kan worden aangebracht aan de achterzijde van de lift. Plafondplaat hoogte = Panel height + 87 mm Plafondplaat breedte = max.
- Pagina 10 Installation diagram: • © Audipack...
- Pagina 11 Technical specifications: • Power supply 230 VAC • Power consumption • Thrust motor power 6000N • Opening angle 100 degrees • Max. load (tv + ceiling panel 30 Kg) • © Audipack...
- Pagina 12 Audipack reserves the right to make changes in specifications and other information contained in this document without prior written notice. The information provided herein is subject to change without notice. In no event shall Audipack be liable for any incidental, special, indirect, or consequential damages whatsoever, including but not limited to lost profits, arising out of or related to this manual or the information contained herein, even if Audipack has been advised of, known, or should have known, the possibility of such damages.