Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3.1.
Start-up the filter system
Once the filter system has been properly assembled, the sand chamber filled with sand and the hoses
connected as described above, you may begin with filtration. However, we recommend that you clean and
prepare the new sand that is in the sand chamber
most of the dust and tiny sand particles that may exist in the
particles will end up in your
Do not plug the system in until advised to do so below.
1. Make certain the pump is not plugged in to a power supply.
2. Start with the valve in the "5 – closed" position.
3.
If you have not done so already, fill your pool with
above the top of the hose intake
4.
Release the shut off valve at the intake port
(skimmer), remove the plug to allow the water to flow into the intake hose.
5. With the filter-pump system installed in a location level lower than your
automatically flow into the pump-filter
6. Allow the filter tank to fill with water.
7. Check for leaks and make any necessary adjustments. Be-cause of tolerances (in consequence of the
production process), it is possible that it may be necessary to use a Teflon tape additionally which has to
be wrapped around the connections, before the connection tube is fixed, to correct these tolerances.
8. Follow the backwash process described below.
3.2.
Backwash process
1. Disconnect the filter pump from the power source.
2. Attach backwash hose (not included) to backwash port.
3. Place the multi-port valve in the "4 – backwash" position.
4. Reconnect to power source.
5. Run filter in backwash mode until discharge water is clear.
6. Disconnect the filter pump from the power source.
7. Place the multi-port valve in the "2 - rinse" position.
8. Reconnect to power source.
9. Allow filter to run for 60 seconds to remove any remaining residue from pump and valve.
10. Disconnect the filter pump from the power source.
11. Place the multi-port valve in the "1 - filtration" position.
12. Reconnect to power source.
13. Your filtration system is running and ready for further operation.
first.
pool.
To clean the sand, please follow the instructions below.
(skimmer)
and return ports in the pool.
(skimmer)
system.
Cleaning the sand prior to filtering your pool will remove
sand.
If you move straight to filtering, these
Ensure that the water level is at least 2,5 – 5 cm
water.
in the
pool.
If you plugged the intake port
pool's water level – water will
|
EN
24
Advertenties
Hoofdstukken
Inhoudsopgave
