Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3
1
ANT.A
POWER
2
10
RECEIVER FRONT PANEL
Operation
Fix the two antennas correctly. Switch on the power of receiver, the red indicator of power will come on
to show it's working normally. Switch on the power of transmitter, the red indicator RF/channelA, RF/
channelB, will come on to show the signal is strong or not when it's working. AF LEVEL green indicators
are blinking to show the audio level is high or low in using this wireless microphone system. Adjust
the volume of the receiver/transmitter/amplifi er according to request. Please switch off the receiver/
transmitter/amplifi er when this wireless microphone system is not being used.
XLR MIXED
11
RECEIVER REAR PANEL
SQUELCH
The squelch control on the rear of the receiver is preset well at the factory, if you must use the system
in an area with considerable RF interference and there is some noises from the receiver when your
transmitter is off, you can adjust the squelch control, so the system will receive the signal from your
transmitter only but squelch or eliminate the unwanted background RF noise. This adjustment can cause
reduction in useable range of the wireless transmitter, so set the control to the lowest position that
reliablely mutes the unwanted RF signals.
Note that switching the microphone on and off can cause interference that will be heard if the
microphone volume level of the amplifi er system is still set high.
5
6
VO LUME
RF
AF L EVE L
CH AN NE L A
4
1. Power Light
2. Power Switch
3. Antenna
4. CH-A Volume Control
5. CH-A RF Signal Light
SQB
MIXED
CH-A
12
13
11. Balanced mixed output jack
12. Unbalanced mixed output jack
13. CH-A unbalanced output jack
14.Squelch adjuster
15. DC power in
PROFESSIONAL 2-CHANNEL WIRELESS SYSTEM
6. CH-A AF Level
7. CH-B Volume Control
8. CH-B RF Signal Light
9. CH-B AF Level
10. Rack Mounting
SQA
14
5
8
9
VO LUME
RF
AF L EVE L
CH AN NE L B
7
DC IN
12V/500mA
15
3
ANT.B
10
Advertenties
Inhoudsopgave
