Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2. Make sure the Rollers Grinding Head is placed into
the unit. See section of Changing the Rollers Grinding
Head on how to re move and replace head.
3. Remove the protective cover from the unit and it is
ready to Use.
4. Switch on (Fig.1)
5. Gently rotate (back and forth or side to side)(Fig.2)
The callus/corn/hard skin area for 2-3 seconds. Dot
not press hard-gently glide the unit over desire area.
The unit will stop if it is press too hard on the skin.
Stop and check if you have
achieved the softness you desire. lf not, go over the
area for 2-3 more seconds and check again. Continue
to use this method until the level of smoothness is
obtained.
Warning: stop using if skin becomes sore or inflamed.
Warning: Do not use on skin tor more than 2-3
seconds at a time.
5. Turn the unit off (Fig.3).
6. Rinse the skin or use a wet towel to get rid of the
excess dead particles.
7. To clean this Callus Remover, please see the
Cleaning section.
8. Keep the protective cover on your unit when it is
not in use.
1
2
3
CHANGING THE ROLLERS GRINDING
HEAD
Change the Rollers Grinding Head as needed for
best result. The Rollers Grinding Head last for a few
sessions depending on frequency of use and size of
area being treated. Replace as needed. Make sure the
unit is turned off before replacing the Rollers Grinding
Head.
1.One hand hold the head, another hand press in the
release button, on the side of the unit, the head will
tack out (Fig.4 & 5).
2. Place a new Rollers Grinding Head into the unit
until you hear a "click' sound. Be sure to insert the
new head into the unit, it has been firmly installed.
Changing the Rollers Grinding Head Note: Do not
turn your unit On if the Rollers Grinding head is not
attached.
4
5
Advertenties
Inhoudsopgave
