Advertenties
Beschikbare talen
Beschikbare talen
Manual
ENG
5. Instruction sensing function
When rubbish or any part of your body is close to the sensing areaapprox.15-25
cm), the lid will open automatically. After leaving the sensing area, the lid will
turn off automatically after about 5 seconds.
6. Manual operation
Press the button on the left to manually open and close the bin lid. The lid will
stay open for 5 minutes.
7. Sterilization
A. Manual sterilization
Press and hold the right button for 3 seconds to open the photocatalytic
sterilization function, which operates for 10 minutes. Sterilization process
induction switch cover function can still run, while the button long open
function is temporarily disabled. The sterilization process can be terminated in
advance by pressing the right button again.
B. Intelligent sterilization
Since the power is turned on, photocatalytic germicidal efficacy automatically
starts every 12 hours. The sterilization process induction switch cover function
can still run, while the button long open function is temporarily disabled. The
sterilization process can be terminated in advance by pressing the right button
again.
Pure Sensor Bin
Trouble
Lid opens unusual
Lid closes unusual
Lid opens slowly
Note
If these solutions do not work, please contact us in time. Do not repair the waste
bin yourself.
1. When you install the batteries, please take note of the +/- instructions.
2. Be sure to use a neat cloth to clean the trash bin. Do not flush the trash bin.
Water can damage inner electric elements. Do not switch on power if there is
water inside the trash bin.
3. Do not push or flip the lid to prevent it from damaging.
4. When power users up, replace the batteries in time to avoid liquid leaking. This
may cause damage to the electric elements.
5. Avoid to use the trash bin under sunlight or wet surroundings.
6. Keep sensing area clean to ensure normal function of the sensor.
7. Do not mix acidic batteries and alkaline batteries or rechargeable batteries and
disposable batteries.
8. Do not repair the trash bin or replace elements yourself. The damage you may
cause is not included in the warranty.
How to solve
1. Check whether the batteries are installed properly
according to"+""-"instruction or check whether lithi-
um battery incurs low power ,and then re-open the
power source switch.
2. Check whether the sensing area is clean or not,
please use a neat cloth to wipe if it is dirty.
1. Check whether the sensing area is clean or not,
please use a neat cloth to wipe if it is dirty.
2. Check whether electic circuits are damp. If so, please
do not connect power source. You can only use the
bin if it is dry.
3. Check whether there is any obstacles around the lid.
If yes,please remove it.
1. Dry battery may incur low power, please replace it.
2. Lithium battery may incur low power, please
recharge it in time.
Advertenties
