Advertenties
Beschikbare talen
Beschikbare talen
EN
Manual
Warning:
New batteries must be recharged and discharged 3~5 times before
their full function use time is released. The rechargeable battery is
built into the device and can be replaced when needed. Do not throw
the battery into the fire, otherwise it may explode. Batteries may also
explode if being damaged, please handle and disposal these according
to local conditions and regulations. After 3 months long storage, it
needs to completely be discharged and recharged for at least 80%. The
battery used in this device may present a risk of fire or chemical burn if
mistreated. Do not disassemble, short contacts, heat above 60°C (140°F),
or incinerate. Keep away from children. Do not disassemble and do not
dispose in a fire.
- Ensure that the device does not come into contact with heat sources,
hot objects or naked flames.
- Do not attempt to charge the device when the battery is damaged.
- Leaks from battery cells can occur under extreme conditions. If the
liquid gets on the skin, wash it immediately with soap and water. If the
liquid gets into the eyes, flush them directly with clean water for at least
15 minutes and seek medical attention.
Installation
1. Do not install the lamp on the gasket base yet (see point 4)
2. The silicone gasket + base is fixed around the handlebar
3. Fasten the silicone strap and lock it at the desired position firmly but
carefully at the same time and adjust when needed.
4. Assemble the lamp on the mount base card slot when set correctly and
place it under eaves and lower as horizontal to not blind other drivers.
5. Install the horn button at same way as point 3 on your left or right side use
and make sure your finger can touch the button while riding your bike.
Assemble
Disassemble
Warning: The horn is very loud, so be careful during use nearby your
ears and other peoples ears.
Tip: When installing, align with the card slot and slide into it. If you feel
the obvious clicking, it indicates that the installation is complete. When
removing the switch, press it and slide out.
Use
The solar led light can be turned on or off by the ON/OFF button:
1.Light on
Press the ON/OFF button to activate the lamp and change to 2 other light
modes by pressing repeatedly 1 by 1.
2. Light off
Press and hold the ON/OFF button to OFF again, the lamp is turned OFF
completely. The solar cells will charge the battery without activating the lamp.
Leave the lamp in this position to charge in sunny days so the battery can be
fully charged before using it or when not in use for a longer period of time to
protect the battery.
3. Horn button
Press 1x long or short to activate the horn sound short or longer during riding.
Tip: If you want to change the horn sound way press and HOLD the horn
button for longer than 5 seconds to choose 1 of the 7 desired sounds and
release when you make your choice.
Notes and warnings
- The led light will be heated in the use process, which is a normal
phenomenon. Please pay attention to keep heat dissipation (such as riding
heat dissipation).
- This product has a very high brightness. Close to the eyes may make people
dizzy. Do not point directly into the eyes, please put it in a place that children
can't touch/use it.
- When the product will not be used for a long time, please place the product
in a place with sufficient sunlight, with a charging time for at least 1 – 3
days in OFF position. For keeping the function of the battery, you'd better
FlinQ Solar Horn Bike Light
Advertenties
