Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
1. Select [MENU] by pressing MODE.
2. Select [DATALOGGER] and press CAL.
Start the data-logging:
1. Select [STORE] and press CAL.
2. Select [RANGE] and press CAL.
3. Select the desired range and press CAL.
4. Select [INTERVAL] and press CAL.
5. Select the desired time interval between the data-logging and press CAL.
6. Select [NUMBER] and press CAL.
7. Select the desired number of values to be data-logged and press CAL.
8. Select [START] and press CAL.
9. Starts the data-logging according to the previous settings while a blinking
[LOG] appears. When manual data-logging has been selected, press PRINT to
put a next measurement into memory. In the meantime the display shows the
logging-number e.g. [#0027].
View the stored values on the display:
1. Select [RECALL] and press CAL.
2. Select [TABLE] or [PRINT] to display or print the stored data and press CAL to
continue. Follow the instructions on the screen.
Erase the stored values:
1. Select [ERASE] and press CAL. Follow the instructions on the screen.
1. Select [MENU] by pressing MODE.
2. Select [RS232] and press CAL.
3. Select [BAUDRATE] and press CAL.
4. Select the desired baudrate and press CAL.
5. Select [INTERVAL] and press CAL.
6. Select the desired interval between the transmitted data and press CAL. Pre-
set to zero if no automatic transmitting is required.
7. Select [IDENTIF. No.] and press CAL.
8. Enter an indentification number for the transmitted data and press CAL.
C931 • C932 • C933
Data-logging
RS232
8
Advertenties
Inhoudsopgave
