Gerelateerde Handleidingen voor Audipack 261125
Samenvatting van Inhoud voor Audipack 261125
- Pagina 1 Gebruiksaanwijzing en installatievoorschriften relaisbesturing Art.nr. 261125 261125 relaisbesturing Installation manual relay control ref. 261125 261125 relay control Copyright Audipack...
-
Pagina 2: Opmerking
Note: Your Audipack product is equipped with a relay control as below. This control has been designed to control a single phase tube motor (with thermal safety device or rotation motors with integrated brake). - Pagina 3 (voorbeeld besturing 261125) (Example relay control 261125) Copyright Audipack...
-
Pagina 4: Omschrijving Connector-Aansluitingen
Aarde aansluiting Pin 1 direction UP Pin 2 direction DOWN Pin 3 neutral Pin 4 earth connection Connector 3: Optionele IR / RF PCB connector Connector 3: Optional IR/RF PCB connector Connector 4: Programmeer connector. Connector 4: Programming connector Copyright Audipack... - Pagina 5 Pin 1 Externe bediening NEER Pin 2 Pin 3 Externe bediening OP Pin 1: external control DOWN Pin 2: GND Pin 3: external control UP SW3: Printschakalaar Impuls Push SW3: Print switch impulse push = OFF ON = ON Copyright Audipack...
-
Pagina 6: Installation And Connections May Only Be Carried Out By Qualified Staff
While the machine is in motion, the operator should have full sight over the machine Het bedieningsconsole moet dermate geïnstalleerd zijn dat de bediener altijd zicht heeft op het product. The control buttons have to be installed in a place which offers the operator full sight over the machine Copyright Audipack... - Pagina 7 Bij breuk of schade aan het product dient de bediener de reparatie door een erkend bedrijf of Audipack uit te laten voeren. If the machine is damaged or fractured, the operator should have the machine repaired by a qualified installer or by Audipack.
-
Pagina 8: Technical Specifications
Aansluitsnoer moet voldoen aan (3x1mm² ) EN60227 De randaarde stekker moet voldoen aan EN60083 of NEN1020 Technical specifications 230 Volt 50 Hz. 500 VA The power cable must be conform (3x1 mm²) EN60227 The earth power plug must be conform EN60083 or NEN1020 Copyright Audipack... -
Pagina 9: Installatievoorschrift
Connecting the print to earth should be carried out using faston connectors Technische eigenschappen en voorwaarden. De faston moet voldoen aan de onderstaande afmetingen. Technical specifications and conditions The instructions of the tools have to be followed for the fitting of the connectors. Copyright Audipack... -
Pagina 10: Technische Gegevens Female Faston
Wire/Cable Type = Regular Wire Strip Tin Finish Brass Material Normal Insertion Force With Insulation Support Line = FASTIN-FASTON .250 Crimp Type = "F" Always was RoHS compliant Stock Thickness = .30 mm For Housing Type = Multiple UL Rating = Recognized Copyright Audipack... - Pagina 11 Binding the wiring together All wiring must be wrapped together by a tie-rap to prevent the wiring from falling out of the connector. The tie-rap will always keep the loose thirds in the connector. Copyright Audipack...
- Pagina 12 Notities: Notes: Copyright Audipack...