Advertenties
Beschikbare talen
Beschikbare talen
Before you start
• This appli a nce has a heavy weight. Be careful when transporting it
• Do not lift the appliance by the pipes or the door when moving.
• This appliance must stand vertically on a flat, even surface, to level the appliance use the
leveling feet by turning them until the appliance is as level as possible.
• Do not install onto carpeted surfaces as this prevent adequate ventilation.
•I n stall the appliance in a well ventilated room. The appliance should not be placed near to
any heat sources (cookers, heaters etc.) or in any unheated rooms (garages, outhouses etc.) as
the ambient temperature affects the performance of the appliance.
• Parts that become hot must never be exposed. The back of the appliance must therefore be
placed against the wall not forgetting the customary distance for ventilation. Allow 300 mm
clearance at the rear of the appliance and on each side of the appliance and over the top to
ensure proper ventilation.
• Do not expose the appliance to damp conditions, open air or rain.
• After you remove all of the packaging materials, clean the inside of your refrigerator before
using i t .
• Should the appliance become damaged, contact the service center and do not use the
appliance until you are instructed to do so by a service engineer.
Getting started
Once you have installed your appliance in an appropriate location, follow the start up procedure
below:
• Before you plug in the appliance,clean thoroughly the inside and all accessories.
• Leave the appliance to stand for 2 - 3 hours to allow the refrigerant to settle following instal-
l a tion and cleaning.
• 1f
the appliance has been transported horizontally, i t must be lelt to stand vertically for 1 2
hours before installation.
• Once dry, plug the appliance into the socket. Make sure the voltage of this appliance is in
accordance with the voltage of your energy grid.
• Turn the thermostat to the required setting.
• When using the freezer for the first time or after defrosting, set the thermostat knob to the
maximum position for at l e ast 2 hours before introducing food to be stored, and then adjust it
to the normai position.
Temperature control
The temperature selector knob is located on the ri g ht hand side wall of the refrigerator interior.
The temperature of the chamber is adjusted through the thermostat knob. The numbers 1 ,2, 3,
4,5, 6, do not mean a specific temperature,the lower the number is, the higher the temperature
inside will be and vice versa.
1 1
Advertenties
