Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
User Manual
EN
FireSales Stratus
If the timer is in operation and you disconnect the machine from the mains cable, the Stratus will
re-start in the Timer-Mode as soon as it's reconnected to the mains.
5.
Operation (via DMX)
It is possible to control the Stratus using a control computer that has a DMX output. DMX uses the
5-pin connectors on the smoke machine. When the machine receives a DMX signal, the yellow light on
the control display will light up. The pump and fan can now be controlled from the control console.
Attention: if a fan is connected to the machine, the Stratus uses two DMX channels. Channel 1 is the
pump, channel 2 is the fan
Adjusting the DMX start address:
•
Press the MENU button at the control panel, until three
figures will appear on the LED display.
•
Adjust the requested start address by pressing the
Up/Down-buttons.
•
Save the start address by pressing the Enter-button
once. The start address will also be saved when you
disconnect the machine from the mains supply.
•
The pump (i.e. the amount of smoke) and the fan can now be controlled from the lighting
control console.
•
When the DMX signal disappears, for example because the lighting control console is
switched off, the machine will automatically switch off after 15 seconds.
5.
Operation (Stand-alone)
The Stratus can be used in the stand alone mode. In this mode, the machine works without remote
control and the smoke output and the fan speed can be adjusted on the machine itself.
•
Press and release the MENU button until a „P" and two
figures appear on the display.
•
The smoke output can now be adjusted by
using the UP and DOWN buttons to change the number.
This can be adjusted from 0 to 99.
•
Press the Enterbutton once to start the fogging
process. The machine now produces fog until the
Enter-button is pressed again. The output can be
changed during the fogging process.
14
FireSales Stratus
www.FireSales.nl
Advertenties
Inhoudsopgave
