Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN - Instruction Manual Brew Monk Titan
2.5.2 Auto Mode Setting
1. Switch on the device, then press AUTO button.
2. S1 will be shown on the top left corner, input the 3 settings - TEMP, TIMER and POWER
(as in manual mode using "+" and "-").
3. After you have set the 1
Steps 3 to 9 are set as step 1 and 2. For each step (3-9) press the
conrm and to go to the next step.
4. Once
TEMP
5. Setting hop reminder in boiling process: After setting the TEMP, TIMER and POWER for
boiling, press AUTO. Set time or hop 1 using "+" and "-". Press TIMER button for 2
3
, ... hop reminder. For example: 60 minutes boiling and ater 10 minutes rst hop
rd
addition, the hop reminder TIMER should be 50 minutes.
6. When you have entered the required steps (up to 9), press the START button to conrm
the above step settings. The brewing process will start. The current step will blink in the
upper left corner.
7. If 9 steps are too much for your recipe, set all temperatures below boiling by pressing
TEMP button after your last step. The programme only supports one boiling setting in
each recipe. You can adjust the boiling power during operation anytime.
2.5.2.1 During MASHING and BOILING
1. When 1
will not proceed with the 2
It is the ingredients lling reminder.
2. The boiling reminder is same as above, when machine nishes the step beore
boiling, there is an audio signal (reminder ringing). The programme will not
proceed with the boiling step unless you press the AUTO button or conrmation.
It is the sparging reminder.
3. PAUSE button will stop the Brew Monk and timer temporarily, so you can
modify the data, afterwards press
4. If you press the START button when auto mode is running, this will skip the
current step.
5. If you press the
appears on the display and a bell sounds for 30 seconds. Press the
again to go to
2.5.2.2 Memory Function in Auto Mode
1. After setting all desired data in auto mode, press STOP button until BLANK PAGE
appears. Please do not switch off the machine! Follow the steps below for
saving the data.
2. Press MANUAL button to enter manual edit page, subsequently press MANUAL
button for 5 seconds and then release it. You can save the last settings in manual
and automatic mode. You will hear an audio signal (ringing sound) as soon as this
is done.
3. Switch off/on the machine, then press AUTO button, the 1
programme will be shown on the display.
4. Press START button, machine starts working.
5. Our programme does not support batch storage. For each entry, you need to
repeat the instructions above.
28
step, press
st
is set to 100°C,
MASHING
step is nished, there is an audio signal (reminder ringing), programme
st
nd
STOP
button to skip all steps, the machine stops working.
BLANK PAGE
.
AUTO
button again, then enter the 2
is automatically changed to
step unless you press the AUTO button to conrm.
to continue.
AUTO
step setting.
nd
button to
AUTO
.
BOILING
,
nd
END
button
STOP
step of last chosen
st
Advertenties
Inhoudsopgave
