Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4400EJ only nozzles:
Juniper Display: The Juniper nozzle (marked with J
on in inside of the nozzle cone) uses the 3/8" x 4" bolt.
Model
Height
4400EJ
The Redwood nozzle uses the 3 self tapping screws to
attach over the pump housing and the Y Insert must be
installed.
Model
Height
4400EJ
4.9 m
The Spruce nozzle uses the three self tapping screws
to attach over the pump housing and the Y Insert must
be removed.
Model
Height
4400EJ
4.1 m
12
Width
1.8 m
8.8 m
Width
1.5 m
Width
3.0 m
Installation Instructions
STEP ONE
Use the ropes to position the Unit in the desired loca-
tion in the pond/lake (secure the cord near power
source to prevent it from being dragged into the wa-
ter). Anchor the ropes or secure them to the shoreline
so the ropes are free of slack, but not tight. To prevent
twisting of the unit due to torque, you should place
the anchor at least 3m from the float for each meter of
depth (Ex. A 3m deep pond would require an anchor
9m horizontally from the float.) For ease of removal,
you may choose to keep at least one anchor within
reach from shore, just below the water's surface.
Correct Anchoring
Incorrect Anchoring
STEP TWO (ALTERNATE INSTALLATION)
In ponds where the water level fluctuates significantly,
you may need to suspend a small weight (30cm of
2.54cm galvanize pipe works well) at the mid-point of
the rope to take up any slack as the water level drops.
The weight should be light enough so the Unit can rise
as the water level rises. This can also help hide ropes
by sinking them further below the surface.
Normal Water level
Anchor Rope
Secondary Weight
Low Water Level
High Water Level
STEP THREE
At this time the Fountain or Aerator is ready for opera-
tion. The unit can now be connected to the electrical
Kasco Power
Control Box
Power Cord
Advertenties
Hoofdstukken
Inhoudsopgave
