Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Connecting to the mains / Switching ON and to standby
Connecting to the mains
After connecting all desired equipment as described, you
can connect the Media Center to a wall socket.
1
Make sure all connections have been made before con-
necting the Media Center to the mains supply.
2
First connect the mains lead to the AC-INPUT (9) and
then to a wall socket.
> The Standby/On indicator (on the STANDBY-ON key 1)
lights up orange.
> The Media Center is now in low power mode, consuming
only a minimum amount of power.
Switching ON
•
To switch on the Media Center from low-power mode,
press the y STANDBY-ON key (1) on the front of
the Media Center.
> The Standby/On indicator (1) goes out.
•
Press the y STANDBY-ON key (1) again to put the
Media Center back to low-power mode.
Switching to standby
•
When the Media Center is switched on (Standby/On
indicator out), press the y Standby key (1) on the
remote control to place the Media Center in standby
mode.
> The Standby/On indicator (1) lights up red.
•
To switch the Media Center on again from standby
mode, press the y Standby key (1) on the remote
control again or the y STANDBY-ON key (1) on the
front of the Media Center.
> The Standby/On indicator (1) goes out.
Note: In both low-power and standby mode the Media Center is
still consuming some power.To disconnect the Media
Center from the mains supply completely, disconnect the
mains lead from the wall socket.
17
Advertenties
Hoofdstukken
Inhoudsopgave
