Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
We recommend that two persons assemble the
product together in order to avoid injuries or
damage to people or the product.
Do not release handle
stand
, until it is fixed in the casket
4
Releasing handle
2
result in damage and / or injury.
The operation in frosty conditions may damage
the product.
There is no maintenance required by the user.
Wind resistance class 1 = wind beaufort scale
4 = 20–27 km / h (small branches start to move,
loose paper is lifted)
Assembly instructions
First locate a suitable installation position on
the ground and mark six hole positions of the
casket
(see fig. A).
1
Drill 5-centimeter-deep holes in the marked
places with a broach which has a diameter
of 8 millimeters (see fig. B).
Important: Make sure before locating anchor
bolts
are suitable for surface type. If not suit-
6
able, consult your local hardware or DIY store.
Fix the product on the ground with the anchor
bolts
by hammering them into the pre-drilled
6
holes with a hammer (see fig. C). Tighten the
anchor bolts
with a wrench.
6
Locate the fixing stand
casket
and stand
1
aligned. Fixing stand
max. 300 cm from casket
the fixing stand holes and drill 5-centimeter-
deep holes in the marked places with a broach
which has a diameter of 8 millimeters (see fig. E).
Fix the stand
with the anchor bolts
4
hammering them into the pre-drilled holes with a
hammer (see fig. F). Tighten the anchor bolts
with a wrench.
Opening awning (see fig. G)
Hold the handle
2
stand
.
4
6
GB/IE/NI
after removing from
2
.
1
without attention may
position ensuring
4
are at same level and
4
can be mounted at
4
(see fig. D). Mark
1
by
6
and walk to the fixing
Insert the hook on the top of stand
hook mouth
Insert the front bar into the bar holder
of stand).
Closing awning
Hold the handle
(There is a groove to lock the handle
fixing stand
4
and lift up.
Grasp the handle
Move the handle
The fabric will draw back itself into the casket
Cleaning and care
Allow all parts to dry thoroughly before you
pack the product up again. This will prevent the
formation of moulds, odours and discolouration.
Clean this product with a slightly dampened,
lint-free cloth.
Store the product in a sheltered room. Or always
store the dry and clean product at room tem-
perature.
Disposal
The packaging is made entirely of recyclable materials,
which you may dispose of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
Warranty
6
The product has been manufactured to strict quality
guidelines and meticulously examined before deliv-
ery. In the event of product defects you have legal
rights against the retailer of this product. Your legal
rights are not limited in any way by our warranty
detailed below.
4
(under the handle
3
2
and pull back a little bit
2
, so it is hard to pull up directly.)
and walk to the casket
2
slowly and horizontally.
2
into the
).
(bottom
5
and
2
.
1
.
1
Advertenties
Inhoudsopgave
