General usage purpose
The product serves as a vision aid when snorkel-
ling and protects the eyes against direct contact
with the water. To make snorkelling and moving
ahead easier we recommend the use of flippers.
Size selection
S/M
(SM-10452)
L/XL
(SM-10453)
Measure the distance from the base of the nose
to the bottom of the chin with mouth closed and
select the size of the product accordingly.
Note: To check the fit of the product put it on
without the snorkel. Place your hand on the
snorkel connection and breathe in. If the product
presses against your face it is watertight.
Attaching the snorkel (fig. B)
Put the snorkel (2) on the mask frame (1) and
push the recess (2a) on the end of the snorkel
over the ridge (1a) on the upper part of the
mask frame until the snorkel sits firmly.
Removing the snorkel (fig. B)
Pull the snorkel (2) off the mask frame (1).
Putting the full-face snorkel
mask on (fig. C)
1. Loosen both ends of the head strap. Hold the
full-face snorkel mask in front of your face with
one hand.
2. Carefully lead the head strap back behind
your head with your other hand. Pull evenly
on both ends of the head strap until the mask
sits firmly and comfortably. Make sure that the
full-face snorkel mask seals tight and that no
water can leak in.
Removing water
If some water leaks into the product despite the
splash guard, you can remove it by blowing it
out of the product with a quick, forceful blast
from the blow-off valve.
6
GB/IE/NI
Removing the full-face snorkel
mask
Loosen both ends of the head strap. Carefully
pull off the head strap from the back of your
head over your forehead.
Correcting defects of vision
If you wish to reduce a defect in vision by insert-
10 - 11.5cm
ing vision-correction lenses consult your specialist
dealer or your optician.
11.5 - 13cm
Replacing valves
The product comes with two replacement valves
(4). When required, pull the two lateral valves
out from inside the mask and replace them with
the replacement valves.
Attaching the camera mount
To use the product together with the camera
mount proceed as follows:
1. Remove the snorkel (2).
2. Slide the camera mount (3) onto the mask
3. Attach the snorkel to the mask frame (fig. D).
4. Attach your camera (not supplied) to the
Storage, cleaning
When not in use, always store the product clean
and dry at room temperature.
Remove the snorkel from the mask and clean
both parts after each use in fresh water. Then
allow both of them to dry properly.
IMPORTANT! Never clean the product with
harsh cleaning agents.
Disposal
the reach of children. For further information
about disposal of the product no longer needed,
contact your local council. Dispose of the
product and the packaging in an environmental-
ly friendly manner.
frame (1) (fig. D).
camera mount.
Dispose of the product and packaging
materials in accordance with current
local regulations. Store the packaging
materials (foil bags, for example) out of