Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
When securing the drill stand with a vacuum pad to the workpiece,
install the pad on a smooth, clean, nonporous surface. Do not
secure to laminated surfaces such as tiles and composite coating.
If the workpiece is not smooth, flat or well affixed, the pad may pull
away from the workpiece.
Ensure there is sufficient vacuum before and during drilling. If the
vacuum is insufficient, the pad may release from the workpiece.
Never perform drilling with the machine secured by the vacuum
pad only, except when drilling downwards. If the vacuum is lost, the
pad will release from the workpiece.
When drilling through walls or ceilings, ensure to protect persons
and the work area on the other side. The bit may extend through the
hole or the core may fall out on the other side.
Ensure that the drill is securely attached to the drill stand before
using it. Otherwise, the drill may slip in the drill stand, which can lead
to a loss of control.
Secure the drill stand on a stable and even surface. If there is a
chance that the drill stand will slip or wobble, the safe and steady
operation of the drill cannot be guaranteed.
Store idle drill stands out of the reach of children. Do not allow
persons unfamiliar with the tool or these instructions to operate
the tool. Tools can be dangerous in the hands of untrained users.
Before carrying out any work on the drill stand or drill, during
work breaks and when not using the drill stand, secure the drill
stand against unintentional movement by tightening the parking
brake.
The safety and operating instructions for the drill stand and the
accessories being used are to be strictly observed!
Always work in a carefully considered way and do not use the tool
if you are lacking consideration.
Store the machine in a safe manner when not being used. The
storage location must be dry and lockable. This prevents the
machine from storage damage, and from being operated by untrained
persons.
For further safety instructions, see the enclosure.
Electrical Connection
The PLD 182.1 NT is made in protection class I. For protection purposes
the machine can only be run with a GFCI. The machine is standard
equipped with a PRCD switch in the cord which allows to connect the unit
direct to a socket.
21
Advertenties
Inhoudsopgave
