Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The power adaptor continues to draw a
small amount of electricity, even without the
radio being operated, as long as the power
adaptor is connected to the power supply . To
completely switch off the power adaptor, it
must be disconnected from the mains network .
Do not subject the product to physical shock or
strong vibrations .
If smoke or unusual sounds are observed,
immediately unplug the power adaptor from
the power supply .
The power adaptor shall not be covered .
Disconnect the power adaptor from the power
supply when the product is not in use and
before cleaning .
Let the product dry completely before
connecting it to the mains supply and before
storage . Allow the product to cool down
completely before storage .
NOTE: This product is equipped with rubber
feet to protect delicate surfaces . It cannot be
ruled out that furniture care agents will attack
or damage the rubber feet .
˜ Start-up
˜ Requirements for the set-up
location
For the safe and trouble-free operation of the
product, the set-up location must fulfil the following
requirements:
When setting up the product, place it on a firm,
flat and horizontal surface . Use the fold-out
foot
.
14 ]
[
The surfaces of some items of furniture might
contain components that can soften the rubber
feet of the product . If necessary, place a mat
under the product's rubber feet .
Set up or mount the product in such a way
that the provided ventilation openings and the
loudspeaker
are not covered .
[
16 ]
Do not operate the product in a hot, wet or
extremely damp environment or in the vicinity
of flammable materials .
The mounting location must be selected so that
the product is not exposed to vapours . Do not
install the product directly over a hotplate .
˜ Installation under a wall
cupboard
Using the supplied mounting plate
install the product e .g . under a wall cupboard .
Proceed as follows to mount the product:
Slide the mounting plate
remove it from the product .
Find a suitable installation location for the
product (see "Requirements for the set-up
location") .
Hold the mounting plate
installation location . Ensure that the front edge
of the mounting plate is approx . 3 .3 cm behind
the front of the cupboard so that the product is
flush with the cupboard after installation . The
side edges of the mounting plate
spaced approx . 5 .8 cm away from adjacent
cabinets or walls .
Mark the 4 mounting points with a pencil .
Using a pin or nail, make a small depression at
the respective marking points . In hardwoods,
drill a hole with a depth of approx . 5 mm in the
markings using a Ø 2 .5 mm wood drill bit . Be
careful not to drill the hole all the way through .
If required, place the supplied spacers
between the cupboard and the mounting plate .
If you are using the spacers
the long mounting screws
Screw the mounting plate
mounting screws (
18 ]
[
With the top of the product against the
mounting plate
, push the product back until
11 ]
[
it clicks into place .
Check to ensure that the product is properly
locked in place and safely route the power
cable and the wire aerial .
3 .3 cm
5 .8 cm
, you can
[
11 ]
to the rear and
[
11 ]
under the
11 ]
[
must be
[
11 ]
17 ]
[
, you will need
[
17 ]
.
18 ]
[
tight using the
[
11 ]
or
) .
19 ]
[
GB/IE/NI
11
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
