Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
REMOVING AND REPLACING THE OVEN DOOR
The oven door can be removed in order to obtain easier access to the oven chamber for cleaning.
• Open the oven door and tilt the safety catch part of the hinge upwards (fig. A). Close the door a little and lift it up and pull it
out towards you in order to remove the door.
• To replace the door, reverse the process. When fitting, ensure that the notch of the hinge is correctly placed on the
protrusion of the hinge holder. After the door is fitted to the oven, the safety catch should be carefully lowered down
again. If the safety catch is not set it may cause damage to the hinge when closing the door.
REMOVING AND REPLACING THE INNER GLASS PANEL
To clean the oven door properly, the inner glass panel can be removed.
• Using a flat screwdriver unhook the upper door slat, prying it gently on the sides (fig. B).
• Pull the upper door slat loose (fig.B, C).
• Carefully pull the inner glass panel from its seat (in the lower section of the door) fig. D.
• Clean the panel with warm water with some washing-up liquid added.
• Carry out the same in the reverse order to reassemble the inner glass panel. Its smooth surface must be pointed upwards.
Important! Do not force the upper strip in on both sides of the door at the same time. In order to correctly fit the top door
strip, first put the left end of the strip on the door and then press the right end in until you hear a "click". Then press the left
end in until you hear a "click".
A
B
C
D
3
2
1
3
2
2
1
English
3
1
37
•
Advertenties
Inhoudsopgave
