Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Vertical cross-section of the stoves (Drawing B):
• The smoke shelf (5). To be placed on top of the steel rail and on the holders in the sides.
• Two-piece smoke defector plate (6). Each half is hung on the hooks located beneath the top plate. The two
halves join in the holders behind the air pipe. Once the stove has been installed, twist the protection off
the two hooks by using pliers or a screwdriver.
• Removable rear plate (2). This must always be mounted if the stove is placed next to a combustible wall.
• Loose heat shield (8) under the ash pan. This can be used as a lid when the ash pan is removed for
emptying.
Connecting and preparing the HWAM Autopilot IHS
Before the stove can be used it must be connected and prepared. Start by connecting the power adapter
to the Airbox that sits in the space under the combustion chamber.
Air box without power supply.
Follow the instructions in the separate manual for linking stove, room temperature sensor and app. If you
do not wish to use an app to control the stove, a remote control can be purchased. In this case, follow
the instructions in the manual supplied with the remote control. The remote control replaces the use of
room temperature sensor and app.
Before the first lighting of the stove, it is important to run a self-test of the system to ensure that every-
thing works as it should. See separate instructions for either app or remote control for more information.
Chimney
The chimney is the "engine" of the stove and it is crucial for the functioning of the woodburning stove.
The chimney draft provides a partial vacuum in the stove. The partial vacuum removes the smoke from
the stove, sucks air through the damper to the so-called pane flush mechanism, which keeps the window
pane soot free, and sucks air into the combustion via the HWAM Autopilot IHS
The chimney draft is created by the differences in temperature inside and outside the chimney. The higher
the temperature within the chimney, the greater the draft. A brick chimney takes longer to warm up than a
steel chimney. On days where the weather and wind conditions create insufficient draught inside the chimney,
it is even more important to warm up the chimney as quickly as possible. The trick is to quickly get some
flames going. Split the wood into extra fine pieces, use an extra firelighter, etc.
If the stove has not been used for a longer period, it is important to check that the chimney pipe is not blocked.
It is possible to connect several devices to the same chimney. However, it is important to first check the
applicable rules.
Even a good chimney can function badly if it is not used correctly. Similarly, a bad chimney may function
well if used correctly.
TM
Air box with power supply.
10
.
TM
Advertenties
Inhoudsopgave
