Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION OF WIRELESS TRANSMITTER
Handheld MIC
Unscrew the battery compartment cover end cap (4) end remove, exposing the
battery compartment. Insert a fresh 9V battery, observing polarity. Re-attach
the battery cover. Turn on the microphone by sliding the power switch (3) to ON
position. The battery LED indicator (2) will light green, indicating full battery
strength. In the case of a low or dead battery, the battery LED will extinguish,
indicating that the battery should be replaced with a fresh one. The IR indicator
in the amplifier should now be it. To preserve battery life, turn the microphone
off when not in use. If you are not going to use the microphone for a long period
of time, take out the battery from microphone to avoid possible battery leakage
to damage the microphone.
Body Pack Transmitter (option)
Open the battery cover and insert a fresh 9V battery, observing the correct polarity. And then
close the cover. Plug in either the clip-on or the headset microphone supplied. To use the clip-
on MIC, attach it at chest level. Do not place too close to the mouth-a distance of about six
inches usually works best. To use the headset MIC, place it on the head and adjust the MIC
boom so that the MIC is about one inch to the side of the front of the mouth.
(Note: The clip-on or headset MIC wire is also the transmitting antenna. Rolling up or shortening
the wire may during use and keep it as straight as possible.)
Turn on the transmitter by sliding the power switch to ON position. The battery LED indicator will
light red shortly and of a low or dead battery, the battery LED will not light at all, indicating that
the battery should be replaced with a fresh one. The IR indicator on the amplifier should now be
it.
OPERATION OF WIRED MICROPHONE
Connect wired dynamic MIC to MIC in jack and turn on MIC.
NOTE:
Wired, wireless microphone and guitar input volume can be adjusted through microphone
volume control. Adjust echo and bass/treble controls of the amplifier to a comfortable listening
level as desired.
OPERATION OF MP3 PLAYER
Press MP3 button repeatedly until MP3 indicator light.
Insert flash drive into USB port or SD/MMC card into D/MMC card slot, it will play the
music in flash drive or M/MMC card automatically. Mp3 play indicator will light.
Press PREV button to go to last track. Press and hold the button to fast backward.
Press NEXT button to go to next track, Press and hold the button to fast forward.
Press PLAY/PAUSE button to pause playing.
Press REPEAT button repeatedly to select REPEAT ONE or REPEAT ALL. REPEAT
ONE or REPEAT ALL indicator will light.
1. MIC in jack
2. Battery LED
3. Power Switch
4. Antenna
5. Headset MIC
6. Clip-on MIC
Advertenties
Inhoudsopgave
