Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
N O T E S
› LAVA
infrared heating devices comply with the relevant
®
safety requirements.
› Installation and initial start-up, as well as repairs and servicing,
may be carried out by a licensed specialist or qualified individ-
ual only. All safety regulations must be observed. This person
must verify first whether the electrical in-house system com-
plies with the relevant standards. The responsibility of the
manufacturer is limited to supply of the device.
› Comply with country-specific safety regulations.
› Comply with local safety precautions.
› The devices are suitable for the installation on walls and on
ceilings.
› Protective areas must be observed in accordance with DIN
VDE 0100, part 701, when installing the device in bathrooms.
› Minimum distances must be adhered to.
C L E A R A N C E S
INSTALLATION AND MINIMUM DISTANCES:
LAVA
infrared heating devices have to be mounted so that
®
flammable objects cannot catch fire. Be absolutely sure to
comply with minimum clearances, in particular to highly com-
bustible objects such as curtains, upholstered furniture, etc.
Please also make sure that the infrared heater can radiate
freely into the room.
ATTENTION:
Strain of any kind on the surface,
whether from persons or objects leaning against it
or from other forces, must be avoided!
10
NOTE
In case of a ceiling installation, the device must be mounted at
least 1.8 m above the floor.
NOTE
In bathrooms, the device must be mounted so that switches or
other regulators cannot be touched by persons in a bathtub or
shower.
NOTE
Due to the low surface temperature at the rear side (up to
40 °C) the infrared heating may also be mounted on wooden
panelling.
NOTE
The device is not intended for the use in wardrobes and
beneath church benches.
35 mm
Dimensional drawing: minimum mounting clear-
35 mm
35 mm
35 mm
ances
Advertenties
Inhoudsopgave
