Advertenties
Beschikbare talen
Beschikbare talen
Handle installation
Before initial commissioning the handle has to be installed to the machine
vice. Place the handle onto the square of the threaded spindle (Fig.2) and
tighten the same using the supplied hexagonal head cap screw, washer and
spring ring (use socket wrench SW 5) (Fig.3).
Place the sealing cap onto the handle (Fig.4).
Mounting rubber profile
For a better stability of the machine on the work surface fasten the enclosed
rubber profile at the machine table.
Mounting:
Carefully put the machine on the side and fit the rubber profile on the bottom
side of the machine table (Fig. 5 + 6).
Using the rubber profile compensates small unevenness on the work surface
and avoids slipping of the machine on smooth surfaces
Before starting the machine check the correspondence between voltage and
frequency according to the data mentioned on the identification plate.
Voltage differences from + 6 % and – 10 % are allowed.
The machine is made in protection class II.
The tool is equipped with a start-up speed limiter to prevent that swift
automatic circuit breakers are unintentionally triggered.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage Cross section in sq. mm
1.5
230V
50 m
Switching on and off
CAUTION:
Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
To prevent the trigger from being accidentally pulled, a lock-off button is
provided. To start the tool, press the lock-off button (A) and pull the trigger
(B) (Fig.7).
Release the trigger to stop.
Electrical Connection
19
2.5
80 m
Advertenties
